Adjustable Current-Limiting Power-Distribution Switches
NCP383
Adjustable Current-Limiting
Power-Distribution
Switches
The NCP383 is a single input dual outputs power−distribu...
Description
NCP383
Adjustable Current-Limiting
Power-Distribution
Switches
The NCP383 is a single input dual outputs power−distribution switch designed for applications where heavy capacitive loads and short−circuits are likely to be encountered, incorporating two very low RDS(on), N−channel MOSFETs in a single package. Each channel of the device limits the output current to a desired level by switching into a constant−current mode when the output load exceeds the current−limit threshold or a short circuit is present. The current−limit threshold is externally fixed by a pull down resistor placed between Ilim and GND. The power−switches rise and fall times are controlled to minimize current ringing during turn on/off.
An internal reverse−voltage detection comparator disables the power−switch if the output voltage is higher than the input voltage to protect devices on the input side of the switches.
The /FLAGx logic output asserts low during over−current, reverse−voltage or over temperature conditions. The switch is controlled by a logic enable input active low.
Features
2.7 V – 5.5 V Operating Range Current limit: Adjustable up to 2.8 A ± 7.5% Current Limit Accuracy at 2.8 A Very fast Over−Current Detection Response: 2 ms (typ) 1 mA Maximum Standby Supply Current Under Voltage Lock−out (UVLO) Soft−Start Prevents Inrush Current Thermal Protection Soft Turn−off Reverse Voltage Protection Enable Active Low mDFN 3x3 mm Compliance to IEC61000−4−2 (Level 4)
8.0 kV (Co...
Similar Datasheet