Slew-Rate-Limited RS-485/RS-422 Transceivers
TECHNICAL DATA
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX3485
Description The ILX3485 is low-power t...
Description
TECHNICAL DATA
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX3485
Description The ILX3485 is low-power transceivers for RS-485
and RS- 422 communication. IC contains one driver and one receiver. The driver slew rates of the ILX3485 is not limited, allowing them to transmit up to 5Mbps.
These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers. All parts operate from a single 3.3V supply. Drivers are short-circuit current limited and are protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a high-impedance state. The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit.
ILX3485N Plastic ILX3485D SOIC
Device
ILX3485N ILX3485D ILX3485DT
ORDERING INFORMATION
Operating Temperature Range
TA = -40 to 85 C
Package
DIP8 SOP8 SOP8
Shipping
Tube Tube Tape & Reel
Features
Low Quiescent Current: 300µA -7V to +12V Common-Mode Input Voltage Range Three-State Outputs 80ns Propagation Delays, 5ns Skew Half-Duplex Versions Available Operate from a Single 3.3V Supply Allows up to 32 Transceivers on the Bus Data rate: 5 Mbps Current-Limiting and Thermal Shutdown for Driver Overload Protection Enhanced ESD Specifications:
±15kV IEC61000-4-2 Air Discharge
±8kV IEC61000-4-2 Contact Discharge
Pin Description
2012, February, ver. 04
ILX3485
ABSOLUTE MAXIMUM RATINGS
Supply Voltage (VCC...
Similar Datasheet