IR Receiver
FM-6038□□-5CN Series
IR Receiver Modules for Remote Control Systems
Description
The FM-6038□□-5CN is a Bi-CMOS IC for...
Description
FM-6038□□-5CN Series
IR Receiver Modules for Remote Control Systems
Description
The FM-6038□□-5CN is a Bi-CMOS IC for use in infrared remote control system. Small-sized, light-weight, and low current consumption. modules have been achieved by using resin mold. The demodulated output signal can directly be decoded by a microprocessor. The main benefit is the reliable function even in disturbed ambient and the protection against uncontrolled output pulses.
Features
Supply Voltage Range: 2.7V to 6 V TTL and CMOS compatibility Photo detector and preamplifier in one package. Internal filter for PCM frequency Open collector output (built-in Pull-up resistor(40K)) Output active low Enhanced Immunity against all kinds of disturbance light No occurrence of disturbance pulses at output pin within nominal conditions. Short settling time after power On.( below 1msec) Meet RoHS
Application Circuit
Transmitter
IR Receiver Module VCC VOUT
IC
47~100Ω 47uf
VCC
MCU
GND GND
R-C filter recommended to suppress power supply disturbances. R-C filter should be connected closely between VCC pin and GND pin.
Block Diagram
B.P.F Center Frequency
Model No. FM-6032□□-5CN FM-6036□□-5CN FM-6038□□-5CN FM-6040□□-5CN FM-6056□□-5CN
Carrier Frequency (fo) 32 kHz 36 kHz 38 kHz 40 kHz 56 kHz
Page 1
September 2011 Rev 1.2 www.opto-sensor.com.tw
FM-6038□□-5CN Series
Suitable Data Format
NEC code
◆ Sony 15bit
RC5 code
◆ Sony 20bit
RC6 code
◆ RCMM code
Sony 12 bit
◆ RCA...
Similar Datasheet