Document
S6530MG
v 1.0 12.09.2013
Description
S6530MG is a red laser diode emitting at typically 660 nm with rated output power of 30 mW cw, in a standard 5.6 mm TO package.
Maximum Ratings
Parameter
Output power Reverse Voltage Reverse Voltage Operating Temperature Storage Temperature
Symbol
Po VR VRPIN TCASE TSTG
Values Min.
- 10 - 15
Max. 32 2 30 + 50 + 85
Unit
mW V V °C °C
Laser Characteristics (TCASE = 25°C)
Parameter
Emission Wavelength Treshold Current Operating Current Operating Voltage Beam Divergence (FWHM) Slope Efficiency (7.5-22.5mW)
Symbol
λpeak Ith IF VF
ӨII x Ө┴ η
Min. 650
7x n/a 0.5
Values Typ. 660 58 95 2.1 8x28 0.8
Max. 665 68 105 2.6 13x35
Unit
nm A A V deg mW/mA
www.roithner-laser.com
1
Performance Characteristics
Optical Output Power vs Forward Current
Forward Voltage vs. forward Current Peak Wavelength vs. Case Temperature
www.roithner-laser.com
2
Relative intensity vs. Angle Slope Efficiency vs. Case Temperature Threshold Current vs. Case Temperature
www.roithner-laser.com
3
Drawing
All dimensions in mm
Electrical Connection
Lead
Pin 1 Pin 2 Pin 3
Description
LD cathode Case PD anode
www.roithner-laser.com
4
ESD Caution
Always do handle laser diodes with extreme caution to prevent electrostatic discharge, the primary cause of unexpected diode failure. ESD failures can be prevented by always wearing wrist straps, only using a grounding workplace, and following strict anti-static guidelines when handling the laser diode
Safety Advice
This laser diode emits highly concentrated blue light which can be hazardous to the human eye and skin. This diode is classified as CLASS 3 laser product according to IEC 60825-1 and 21 CFR Part 1040.10 Safety Standards.
Operating Considerations
Operating the laser diode outside of its maximum ratings may cause failure or a safety hazard. The diode may be damaged by excessive drive currents or switching transients. If the diode is operated using a power supply, it is strongly recommended to connect the diode with the output voltage set to zero. The voltage should then be increased slowly and with great caution, while at the same time carefully monitoring the laser diodes output power and drive current. The laser diode will show accelerated degradation with increased temperature, and it is advised to keep the case temperature low therefor, by means of heat sinking the device.
© All Rights Reserved The above specifications are for reference purpose only and subjected to change without prior notice
www.roithner-laser.com
5
.