MP100701

MAGNETIC SENSOR MP1005-1007 Series Applications:  Limit Switch Specifications Solid state magnetic proximity sensor in adjustable threaded housing. Features  Excellent output stability over  Open Collector (NPN) output can operating temperature be used with bipolar or cmos range. logic circuits with suitable pull up  Regulated power supply not resistor. needed. - Output switches low (off) when  Reverse battery protection to - the magnetic field at the sensor 24VDC.  Wire: 20awg, tin plated, Radox 150A, Polyolefin insulation  Anodized aluminum housing  South pole activated, works exceeds the operate point threshold - Output switches high (on) when the magnetic field is reduced to below the release point threshold with AS101001 magnet.  Home security  Door position Note: These sensors require the use of an external pull-up resistor , the value of which is dependent upon the supply voltage. Pull-up resistor should be connected between output (Black) and Vcc (Brown). Dimensions inches (mm) Open Collector Sinking Block Diagram Specifications subject to change without notice. Recommended pull-up resistor values: Volts DC: 5 9 12 15 Ohms: 1K 1.8K 2.4K 3K 24 3K Last Update 072512 ...