HC2510C

HC2510C HC2510C Features l l l l l l l l l l l Phase-Locked Loop Clock Distribution for Synchronous DRAM Applications Supports PC-100 and Meets “PC100 SDRAM registered DIMM Specification Rev. 1.2” Distributes One Clock Input to One Bank of Ten Outputs No External RC Network Required External Feedback (FBIN) Pin is Used to Synchronize the Outputs to the Clock Input Separate Output Enable for Each Output Bank Operates at 3.3 V Vcc 125 MHz Maximum Frequency On-chip Series Damping Resistors Support Spread Spectrum Clock(SSC) Synthesizers ESD Protection Exceeds 3000 V per MIL-STD883, Method 3015 ; Exceeds 350 V Using Machine Model ( C = 200 pF, R = 0 ) Latch-Up Performance Exceeds 400 mA per JESD 17 Packaged in Plastic 24-Pin Thin Shrink SmallOutline Package General Description The HC2510C is a low-skew, low jitter, phaselocked loop(PLL) clock driver, distributing high frequency clock signals for SDRAM. The HC2510C operates at 3.3V Vcc and provides integrated series-damping resistors that make it ideal for driving point-to-point loads. The propagation delay from the CLK input to any clock output is nearly zero. Ten outputs provide low-skew and low-jitter clocks. All outputs can be enabled or disabled via the control input(G). Output signal duty cycles are adjusted to 50 percent, independent of the duty cycle at CLK. The HC2510C is specially designed to interface with high speed SDRAM applications in the range of 25MHz to 125MHz and includes an internal RC network which provides ...