Optical Timing Clock
Preliminary
OP4010B
• • • • Quartz SAW Stabilized and Filtered “Diff Sine” Technology Fundamental-Mode Oscillation at 66...
Description
Preliminary
OP4010B
Quartz SAW Stabilized and Filtered “Diff Sine” Technology Fundamental-Mode Oscillation at 663.552 MHz Voltage Tunable for Phase Lock Loop Operations Optical Timing Reference for Forward Error Correction Applications
The output of this device is generated and filtered by narrowband quartz SAW elements at 663.552 MHz. The configuration of this clock is intended to provide a pure signal for optical timing applications in noisy signal environments. The Q/Qbar differential output swing of ±1 volt about 0 vdc has symmetry better than ±1% into loads from 40 ohms to 70 ohms; determined by customer application. The long term frequency accuracy is set by an external reference source allowing this device to complete a Phase Lock Loop design without the usual noise and jitter problems associated with PLL’s.
663.552 MHz Optical Timing Clock
Absolute Maximum Ratings Rating
DC Suppy Voltage Tune Voltage Case Temperature
Value
0 to 5.5 0 to 6 -55 to 100
Units
VDC VDC °C
SMC-08
Electrical Characteristics
Operating Frequency Characteristic Absolute Frequency Tune Range Tune Voltage Tuning Linearity Tuning Sensitivity Modulation Bandwidth Voltage into 50 Ω (VSWR≤1.2) Sym fO Notes 1, 9 2 1 1, 8 2, 10 1,3 1,3 3, 4, 5 3, 4, 6 3, 4, 6, 7 Minimum ±100 0 ±3% 140 50 VO 0.60 49 1.1 2:1 51 -30 -60 -75 -105 -125 -155 2 12 12 1 50 3.13 300 ppm/V kHz VP-P % dBc dBc dBc/Hz dBc/Hz Typical 663.552 +3 Maximum Units MHz ppm VDC
df/dv
Q and Q Output
Operating Load VSWR Symme...
Similar Datasheet