DC-DC Converter and Reset function-IC
TB62217AFG
TOSHIBA BiCD Process Integrated Circuit Silicon Monolithic
TB62217AFG
PWM drive Stepping Motor Driver / Brus...
Description
TB62217AFG
TOSHIBA BiCD Process Integrated Circuit Silicon Monolithic
TB62217AFG
PWM drive Stepping Motor Driver / Brush DC Motor Driver Selectable, DC-DC Converter and Reset function IC
The TB62217FG is a dual stepping motor driver driven by PWM chopper micro step, with 3- channel step-down DC-DC converters and an external-IC reset function. To drive a two-phase bipolar-type stepping motor, a 16-bit latch and a 16-bit shift register are built into the IC. The IC is suitable for driving stepping motors with low-torque ripple in a highly efficient manner. In addition, a signal axis can be switched to serve as a PWM driver for two DC motors. By equipping the stepping motor driver with Selectable Mixed Decay Mode for switching the attenuation ratio during chopping, and also equipping it with a DC-DC converter, it is possible for the IC to supply external voltage. With a built-in timer that starts running when the IC is supplied with power, the IC can be used in resetting (initializing) external devices.
Weight: 0.45 g (typ.)
Features
The following motor combinations can be used.
Stepper (1) (2) (3) (4) (5) (6) Dual motors Single motor Single motor ⎯ ⎯ ⎯ DC Large DC (L) ⎯ Single motor ⎯ Single motor Dual motors ⎯ DC Small DC (S) ⎯ ⎯ Dual motors Dual motors ⎯ Quadruple motors
Note
Hereafter, DC Large will be referred to as DC (L) and DC Small will be referred to as DC (S).
Recommended maximum current Stationary current
The large current standard is achieved by shorting a ...
Similar Datasheet