Two-Phase Stepping Motor Driver
Ordering number : ENN7304
www.DataSheet4U.com
Thick-Film Hybrid IC
STK672-330
Unipolar Fixed-Current Chopper (Externa...
Description
Ordering number : ENN7304
www.DataSheet4U.com
Thick-Film Hybrid IC
STK672-330
Unipolar Fixed-Current Chopper (External-Excited PWM) Scheme and Built-in Phase Signal Distribution IC
Two-Phase Stepping Motor Driver (Square Wave Drive) Output Current: 1.8 A
Overview
The STK672-330 is a unipolar fixed-current chopper type 2-phase stepping motor driver hybrid IC. It features power MOSFETs in the output stage and a built-in phase signal distribution IC. The incorporation of a phase distribution IC allows the STK672-330 to control the speed of the motor based on the frequency of an external input clock signal. It supports two types of excitation for motor control: 2-phase excitation and 1-2 phase excitation. It also provides a function for switching the motor direction. The STK672-330 features an ENABLE pin, a function not provided in the STK672-110. When the ENABLE pin is set low while the clock signal is being supplied, all MOSFET devices are forced to the off state. When ENABLE is set high again later, the IC resumes operation, continuing with the prior excitation timing.
All inputs are Schmitt inputs. The motor current can be set by changing the Vref pin voltage. Since a 0.195-Ω current detection resistor is built in, a current of 1 A is set for each 0.195 V of applied voltage. The input frequency range for the clock signal used for motor speed control is 0 to 50 kHz. Supply voltage ranges: VCC1 = 10 to 42 V, VCC2 = 5.0 V ±5% This IC supports motor operating curr...
Similar Datasheet