Dual Digitally Programmable Potentiometers
www.DataSheet4U.com
CAT5269
Dual Digitally Programmable Potentiometers (DPP™) with 256 Taps and 2-wire Interface
FEATU...
Description
www.DataSheet4U.com
CAT5269
Dual Digitally Programmable Potentiometers (DPP™) with 256 Taps and 2-wire Interface
FEATURES
Four linear taper digitally programmable potentiometers 256 resistor taps per potentiometer End to end resistance 50kΩ or 100kΩ Potentiometer control and memory access via 2-wire interface (I2C like) Low wiper resistance, typically 100Ω Nonvolatile memory storage for up to four wiper settings for each potentiometer Automatic recall of saved wiper settings at power up 2.5 to 6.0 volt operation Standby current less than 1µA 1,000,000 nonvolatile WRITE cycles 100 year nonvolatile memory data retention 24-lead SOIC and TSSOP packages Industrial temperature range For Ordering Information details, see page 15.
DESCRIPTION
The CAT5259 is two digitally programmable poten– tiometers (DPPs™) integrated with control logic and 18 bytes of NVRAM memory. Each DPP consists of a series of resistive elements connected between two externally accessible end points. The tap points between each resistive element are connected to the wiper outputs with CMOS switches. A separate 8-bit control register (WCR) independently controls the wiper tap switches for each DPP. Associated with each wiper control register are four 8-bit non-volatile memory data registers (DR) used for storing up to four wiper settings. Writing to the wiper control register or any of the non-volatile data registers is via a 2-wire serial bus. On power-up, the contents of the first...
Similar Datasheet