SEP Series Standard radial lead type Capacitor
4. SPECIFICATIONS FOR EACH SERIES
Conductive polymer type
SEP
www.DataSheet4U.com
Standard radial lead type,
Series ...
Description
4. SPECIFICATIONS FOR EACH SERIES
Conductive polymer type
SEP
www.DataSheet4U.com
Standard radial lead type,
Series Guaranteed at 105°C for 3,000h
This is a radial lead type using conductive polymer based on the SVP series. Lead free-flow is supported.
Specifications
Items Category temperature range Tolerance on rated capacitance Tangent of loss angle Leakage current 1 ESR Characteristics of impedance ratio at high temp. and low temp. Endurance Conditions 120Hz 120Hz After 2 minutes Based the value at 100KHz +20°C 105°C, 3,000h, Rated voltage applied (2.5V→2,000h), (25V→20V applied) 60°C, 90 to 95%RH, 1,000h, No-applied voltage Flow method (260±5°C X 10s)
Damp heat (Steady state)
Resistance to soldering heat
Marking : Polarity( ), Rated voltage, Rated capacitance (Purple) Lot.No., SEP Characteristics -55°C to +105°C M :±20% Less than or equal to the value of Table10 Less than or equal to the value of Table10 Less than or equal to the value of Table10 Z / Z 20°C 0.75 to 1.25 -55°C 0.75 to 1.25 Z / Z 20°C +105°C ∆C/C Within ±20% tanδ 1.5 times or less than an initial standard ESR 1.5 times or less than an initial standard Leakage current Below an initial standard ∆C/C Within ±20% tanδ 1.5 times or less than an initial standard ESR 1.5 times or less than an initial standard Leakage current Below an initial standard (after voltage processing) ∆C/C Within ±5% tanδ Below an initial standard ESR Below an initial standard Leakage current Below an initial standard (after volt...
Similar Datasheet