SS-12E01-G2.1

www.DataSheet4U.com Research Develop Innovate RDI, Inc. 400 Columbus Avenue Valhalla, NY 10595 : DC 50V 0.5A 1. RATING : 1P2T 2. FUNCTION 3. ELECTRICAL : NON-SHORTING ITEM PRACTICAL 4 TEMPERATURE RANGE STANDARD ATMOSPHERIC CONDITIONS TEST CONDITIONS -16°C ~ + 60°C PERFORMANCE 8. DURABILITY: ITEM 8.1 SOLDERABILITY TEST TEST CONDITIONS THE TOP OF THE TERMINALS SHALL BE DIPPED 2mm IN THE SOLDER BATH OF 230 ± 5°C FOR 3± 0.5 SECONDS. PERFORMANCE THE AREA OF SOLDERING SHOULD BE OVER 75% WITHOUT DEFORMATION OF CASE OR EXCESSIVE LOOSENESS OF TERMINALS ELECTRICAL CHARACTERISTICS SHALL BE SATISFIED. 5 NORMALLY,THE STANDARD RANGE OF ATMOSPHERIC CONDITION FOR MAKING MEASUREMENTS AND TESTS ARE AS FOLLOWS: (1) AMBIENT TEMPERATURE: 5 °C TO 35 °C (2) RELATIVE HUMIDITY: 45 % TO 85 % 6. ELECTRICAL CHARACTERISTICS 6.1 CONTACT RESISTANCE MEASURED AT SMALL CURRENT(100mA OR LESS) 1000Hz APPLY A VOLTAGE OF 500V DC SHALL BE APPLIED FOR 1 MIN. AFTER WHICH MEASUREMENT SHALL BE MADE. (1) BETWEEN TERMINALS. (2) BETWEEN INDIVIDUAL TERMINALS AND FRAME. AC 500V rms(50 - 60 HZ) FOR 1 MIN TRIP CURRENT: 0.5 mA (1)BETWEEN TERMINALS. (2) BETWEEN INDIVIDUAL TERMINALS AND FRAME. TEST CONDITIONS MEASUREMENT SHALL BE MADE AT THE NEAREST POINT OF THE COMPONENT OR AT THE POINT 3mm FROM THE TIP ON THE ACTUATOR(KNOB). 80 m Ω MAX. 100 M Ω MIN. NO DAMAGE TO PARTS ARCING OR BREAKDOWN ETC. PERFORMANCE 200gf± 50gf CHARACTERISTICS SHALL BE SATISFIED WITHOUT DAMAGE OR EXCESSIVE LOOSENESS OF TERMINALS. THE LEVER SHAL...