Document
HIGH–FREQ ALUMINUM ELECTROLYTIC
HD SERIES
SUBMINIATURE (Radial Lead, Horizontal Deflection)
The NTE HD series of aluminum electrolytic non–polarized capacitors are designed specifically for horizontal deflection current correction where high frequency and high ripple current occur.
MECHANICAL SPECIFICATIONS
Lead Solderability: Meets the requirements of MIL–STD 202, Method 208 Marking: Consists of series type, nominal capacitance, rated voltage, temperature range, anode and/or cathode identification, NTE identification. Recommended Cleaning Solvents: Methanol, isopropanol ethanol, isobutanol, petroleum ether, propanol and/or commercial detergents. Halogenated hydrocarbon cleaning agents such as Freon (MF, TF, or TC), trichloroethylene, trichloroethane, or methylchloride are not recommended as they may damage the capacitor.
RATINGS
Capacitance Range: 1.0µf to 10µf Tolerance: ±20% Voltage Range: 25 Volts and 50 Volts
PERFORMANCE SPECIFICATIONS
Operating Temperature Range: –25°C to +85°C (–13°F to +185°F) Leakage Current: I ≤ 0.2CV (measured after 5 minutes of applied rated voltage) I = Leakage Current (µA) C = Nominal Capacitance (µf) V = Rated Voltage (V) Capacitance Tolerance: ±20% (M) measured at +20°C (+68°F), 1kHZ Load Life: 1000 Hrs @ 12V DC, +70°C (+158°F), at specified ripple current Leakage Current: Initial specified value or less Dissipation Factor: < 200% of specified value Capacitance Change: Within ±15% of initial value Shelf Life: 500 Hrs @ +85°C (+185°F), no voltage applied Leakage Current: Initial specified value or less Dissipation Factor: < 200% of specified value Capacitance Change: Within ±15% of initial value
CASE SIZE AND DIMENSIONS:
Insulating Sleeve 15.0 Min
www.DataSheet4U.com
dØ
A ±0.5
L’
5.0 Min
D’ Ø
HD Series Dimensions: Diameter (D Ø) x Length (L): mm
Capacitance (µf) 1.0 2.2 3.3 4.7 5.6 6.8 8.2 25V and 50V 12.5 x 20 12.5 x 25 16 x 25 16 x 31.5 16 x 31.5 16 x 35.5 18 x 35.5 18 x 40 Ripple Current* (Ap–p) 2.0 3.0 4.0 5.0 6.0 7.0 8.0 9.0
ORDERING INFORMATION
HD Series Capacitance Tolerance Voltage 4.7 M 50
10.0
* Allowable ripple current @ 70°C, 12V DC, and 15.75kHZ
HD Mechanical Specs: Dimensions (mm)
Outside Diameter (D Ø) Lead Spacing (A) Lead Wire (d Ø) 12.5 5.0 0.6 16 7.5 0.8 18 7.5 0.8
NTE Electronics, Inc. D Voice (800) 631–1250 (973) 748–5089 D FAX (973) 748–6224 D http://www.nteinc.com
9
.