IC FOR XO TRIMMING
www.DataSheet4U.com
DA9285.004 13 July 2006
IC FOR XO TRIMMING
• • • • • •
DESCRIPTION
MAS9285 is capacitive digital t...
Description
www.DataSheet4U.com
DA9285.004 13 July 2006
IC FOR XO TRIMMING
DESCRIPTION
MAS9285 is capacitive digital to analog converter integrated circuit well suited to make initial offset trimming of the crystal oscillator. The trimming is done by a serial bus and the calibration information is stored in an internal PROM.
MAS9285
Very Low Power Wide Trimming Range Wide Supply Voltage Range Very High Level of Integration Electrically Trimmable Low Cost
FEATURES
Very small size Minimum current draw Wide operating temperature range
APPLICATIONS
OCXO All Crystal Oscillators
BLOCK DIAGRAM
MAS9285
DA CLK PV VDD
Digital
2 3 5
VSS
X1
Figure 1. Block diagram of MAS9285.
1 (11)
DA9285.004 13 July 2006
PIN DESCRIPTION
Pin Description Serial Bus Data Input Serial Bus Clock Input Programming Input Power Supply Voltage Power Supply Ground CDAC Output with Bias Option Symbol DA CLK PV VDD VSS X1 x-coordinate 192 425 656 161 368 629 y-coordinate 152 152 158 855 855 871 Note
Note: Because the substrate of the die is internally connected to VDD, the die has to be connected to VDD or left floating. Please make sure that VDD is the first pad to be bonded. Pick-and-place and all component assembly are recommended to be performed in ESD protected area. Note: Pad coordinates measured from the left bottom corner of the chip to the center of the pads. The coordinates may vary depending on sawing width and location, however, distances between pads are accurate.
ABSOLUTE ...
Similar Datasheet