MINISMDM160

( DataSheet : www.DataSheet4U.com ) Tyco / Electronics Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PolySwitch® PTC Devices Overcurrent Protection Device PRODUCT: miniSMDM160 DOCUMENT: SCD 24370 PCN: 517929 REV LETTER: B REV DATE: MARCH 28, 2002 PAGE NO.: 1 OF 1 Specification Status: Released Maximum Electrical Rating Voltage: 8VDC Current: 40A Notes: 1. All terminations are gold plated. Partial coverage of plating with solder may occur without effect on solderability or electrical performance 2. Devices cannot be wave soldered. 3. Drawing not to scale Marking: Manufacturer’s Mark 160 Part Identification Lot Identification TABLE I. DIMENSIONS: A mm: in:* MIN 4.35 (0.172) MAX 4.75 (0.187) MIN 1.75 (0.069) B MIN 2.00 (0.079) MAX 3.05 (0.120) C MAX 3.60 (0.142) MIN 1.4 (0.055) D MAX 1.7 (0.067) *Rounded off approximation TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS ** TIME TO TRIP ** SECONDS AT 25°C, 8.0A MAX 2.0 RESISTANCE TRIPPEDVALUES STATE POWER DISSIPATION** OHMS WATTS AT AT 25°C 25°C, 8.0V MIN MAX* MAX 0.033 0.099 0.8 AMPERES AMPERES AMPERES AT 0°C AT 25°C AT 60°C HOLD TRIP HOLD TRIP HOLD TRIP 1.80 3.15 1.60 2.80 1.14 2.00 *Maximum resistance is measured 1 hour after reflow. ** Values specified were determined using PCB’s with 0.030”X1.5 ounce copper traces. Reference Documents: Precedence: Effectivity: CAUTION: PS300 This specification takes precedence over documents referenced herein. Re...