SMP253

SMP253 EMI suppressor, class Y2, metallized paper SMD 0.001 – 0.0047 µF, 250 VAC, +100 °C H B TYPICAL APPLICATIONS The capacitors are intended for use as interference suppressors in Y2 applications, line-to-earth. CONSTRUCTION Multi-layer metallized paper. Encapsulated and impregnated in self-extinguishing material meeting the requirements of UL 94V-0. 0.5 L 0.5 TECHNICAL DATA Rated voltage Capacitance range Capacitance tolerance Temperature range Climatic category IEC Approvals Dissipation factor tanδ Insulation resistance 250 VAC 50/60 Hz 0.001 – 0.0047 µF ± 20% –40 to +100°C 40/100/56/B S, UL, CSA Components may be vertically mounted for decreased footprint. See page 69. ≤ 1.3 % at 1 kHz ≥ 12000 MΩ Measured at 500 VDC after 60 s, +23°C The 100% screening factory test is carried out at 3000 VDC. The voltage level is selected to meet the requirements in applicable equipment standards. All electrical characteristics are checked after the test. Test voltage between terminals RECOMMENDED SOLDERING CONDITIONS Electrode temperature, Reflow soldering Preheating temperature should be less than 160°C. The time above 180°C should be less than 1 minute. The peak temperature must not exceed 240°C. Temperature (°C) Max 240 °C 250 200 150 100 50 0 Max 160 °C Max 60 s over 180 °C 0 30 60 90 120 150 180 210 240 270 300 t(s) Recommended reflow soldering profile ENVIRONMENTAL TEST DATA Vibration IEC 60068-2-6 Test Fc EN 132400 3 directions at 2 hour each 10 – 500 Hz at ...