PM25LV512
PMC
Pm25LV512 / Pm25LV010
512 Kbit / 1 Mbit 3.0 Volt-only, Serial Flash Memory With 25 MHz SPI Bus Interface
FEATURES
...
Description
PMC
Pm25LV512 / Pm25LV010
512 Kbit / 1 Mbit 3.0 Volt-only, Serial Flash Memory With 25 MHz SPI Bus Interface
FEATURES
Single Power Supply Operation - Low voltage range: 2.7 V - 3.6 V
Memory Organization - Pm25LV512: 64K x 8 (512 Kbit) - Pm25LV010: 128K x 8 (1 Mbit)
Cost Effective Sector/Block Architecture - Uniform 4 Kbyte sectors - Uniform 32 Kbyte blocks (8 sectors per block) - Two blocks with 32 Kbytes each (512 Kbit) - Four blocks with 32 Kbytes each (1 Mbit) - 128 pages per block
Serial Peripheral Interface (SPI) Compatible - Supports SPI Modes 0 (0,0) and 3 (1,1)
High Performance Read - 25 MHz clock rate (maximum)
Page Mode for Program Operations - 256 bytes per page
Block Write Protection - The Block Protect (BP1, BP0) bits allow part or entire of the memory to be configured as read-only.
Hardware Data Protection - Write Protect (WP#) pin will inhibit write operations
to the status register
Page Program (up to 256 Bytes) - Typical 2 ms per page program time
Sector, Block and Chip Erase - Typical 40 ms sector/block/chip erase time
Single Cycle Reprogramming for Status Register - Build-in erase before programming
High Product Endurance - Guarantee 100,000 program/erase cycles per single
sector (preliminary) - Minimum 20 years data retention
Industrial Standard Pin-out and Package - 8-pin JEDEC SOIC - 8-contact WSON - Optional lead-free (Pb-free) packages
GENERAL DESCRIPTION
The Pm25LV512/010 are 512 Kbit/1 Mbits 3.0 Volt-only serial Flash me...
Similar Datasheet