M29F100T

M29F100T M29F100B 1 Mbit (128Kb x8 or 64Kb x16, Boot Block) Single Supply Flash Memory 5V ± 10% SUPPLY VOLTAGE for PROGRAM, ERASE and READ OPERATIONS FAST ACCESS TIME: 70ns FAST PROGRAMMING TIME – 10µs by Byte / 16µs by Word typical PROGRAM/ERASE CONTROLLER (P/E.C.) – Program Byte-by-Byte or Word-by-Word – Status Register bits and Ready/Busy Output MEMORY BLOCKS – Boot Block (Top or Bottom location) – Parameter and Main blocks BLOCK, MULTI-BLOCK and CHIP ERASE MULTI-BLOCK PROTECTION/TEMPORARY UNPROTECTION MODES ERASE SUSPEND and RESUME MODES – Read and Program another Block during Erase Suspend LOW POWER CONSUMPTION – Stand-by and Automatic Stand-by 100,000 PROGRAM/ERASE CYCLES per BLOCK 20 YEARS DATA RETENTION – Defectivity below 1ppm/year ELECTRONIC SIGNATURE – Manufacturer Code: 0020h – Device Code, M29F100T: 00D0h – Device Code, M29F100B: 00D1h DESCRIPTION The M29F100 is a non-volatile memory that may be erased electrically at the block or chip level and programmed in-system on a Byte-by-Byteor Wordby-Word basis using only a single 5V VCC supply. For Program and Erase operations the necessary high voltages are generated internally. The device can also be programmed in standard programmers. The array matrix organisation allows each block to be erased and reprogrammed without affecting other blocks. Blocks can be protected against programing and erase on programming equipment, and temporarily unprotected to make changes in the application. Each block can be programmed and e...