Simple Phase Controller
Adronic Components GmbH
Simple Phase Control Circuit
TEA1007
Description
Integrated circuit, TEA1007, is designed as ...
Description
Adronic Components GmbH
Simple Phase Control Circuit
TEA1007
Description
Integrated circuit, TEA1007, is designed as a general phase control circuit in bipolar technology. It has an internal supply voltage limitation. With typical 150 mA ignition pulse, it is possible to determine the phase-shift
of the ignition point by comparing the mains sync. ramp voltage with a preset required value. It generates a single ignition pulse per half wave; therefore, it is suitable for capacitive and inductive loads in low cost applications.
Features
vD Current consumption 2.5 mA
D Ignition pulse typ. 150 mA D Voltage and current synchronization
Block Diagram
D Internal supply voltage control
Package: DIP8
Rv = series resistance Figure 1. Block diagram with typical circuitry
TELEFUNKEN Semiconductors Rev. A1, 28-May-96
1 (8)
Adronic Components GmbH
TEA1007
General Description
The phase-shift of the ignition point is determined in the usual manner by comparison between a mains synchronized ramp voltage and a predetermined required value. The capacitor Cö/t between Pin 7 and the common reference point Pin 8 is discharged at the zero transition of the mains voltage via the Vo detector, gate G2 and switch S2. After the end of the zero transition pulse, Cö/t is charged from the constant current source Iö, whose value is adjusted externally with Rö at Pin 3 due to the unavoidable tolerance of Cö/t (Phase 1).
When the potential at Pin 7 reaches the nominal value predetermined at Pin 6, th...
Similar Datasheet