Wide Dynamic Range Image Reject MOPLL
SL2610 Wide Dynamic Range Image Reject MOPLL
Data Sheet Features
• • • • • • • • • Single chip mixer/oscillator PLL comb...
Description
SL2610 Wide Dynamic Range Image Reject MOPLL
Data Sheet Features
Single chip mixer/oscillator PLL combination for multi band tuner for DTT applications Each mixer oscillator band optimized for wide dynamic range RF input stages allow for either single-ended or differential drive PLL frequency synthesizer designed for low phase noise performance Broadband output level detect with onset adjust PLL frequency synthesizer compatible with standard digital terrestrial offsets Four integrated switching ports I2C fast mode compliant ESD protection (Normal ESD handling procedures should be observed)
SL2610/IG/LH1Q SL2610/IG/LH1N SL2610/IG/LH2Q SL2610/IG/LH2N
October 2004
Ordering Information
40 40 40 40 Pin Pin Pin Pin MLP MLP MLP MLP Tape & Reel, Bake & Drypack Trays, Bake & Drypack Tape & Reel, Bake & Drypack* Trays, Bake & Drypack*
*Leadfree
-40°C to +85°C
Description
The SL2610 is a mixer oscillator intended primarily for application in all band tuners, where it performs image reject downconversion of the RF channel to a standard 36 MHz or 44 MHz IF. Each band consists of a low noise preamplifier/mixer and local oscillator with an external varactor tuned tank. The band outputs share a common low impedance SAWF driver stage. Frequency selection is controlled by the on-board I2C bus frequency synthesizer. This block also controls four general purpose switching ports for selecting the prefilter/AGC stages.
Applications
Terrestrial digital receiver system...
Similar Datasheet