DatasheetsPDF.com

IPS4260L Dataheets PDF



Part Number IPS4260L
Manufacturers STMicroelectronics
Logo STMicroelectronics
Description Quad low-side intelligent power switch
Datasheet IPS4260L DatasheetIPS4260L Datasheet (PDF)

IPS4260L Datasheet Quad low-side intelligent power switch HTS S OP20 Product status link IPS4260L Product summary Order code IPS4260L Package HTSSOP20 Packing Tube Order code IPS4260LTR Package HTSSOP20 Packing Tape & Reel Product label Features RDS(on) (typ.) IOUT VCC AMR 0.26 Ω 4 ch 0.5 A 1 ch 2.0 A 55 V • 8 V to 50 V operating voltage range • Four independent protected channels • VCC undervoltage lock-out • High speed operation (tr, tf < 1 μs) • Programmable load curr.

  IPS4260L   IPS4260L



Document
IPS4260L Datasheet Quad low-side intelligent power switch HTS S OP20 Product status link IPS4260L Product summary Order code IPS4260L Package HTSSOP20 Packing Tube Order code IPS4260LTR Package HTSSOP20 Packing Tape & Reel Product label Features RDS(on) (typ.) IOUT VCC AMR 0.26 Ω 4 ch 0.5 A 1 ch 2.0 A 55 V • 8 V to 50 V operating voltage range • Four independent protected channels • VCC undervoltage lock-out • High speed operation (tr, tf < 1 μs) • Programmable load current limitation level by external resistor • Typical operating load current: 0.5 A (per channel) / 2 A (one channel) • Thermally independent junction overtemperature protections • Programmable non-dissipative short-circuit protection (cut-off) by external resistor • Open load (off-state) and short-to-ground activated by external pull-down resistors • Fast demagnetization of inductive loads with integrated catch diodes clamping turn-off transients • Ground and VCC wire break protection • VCC overvoltage protection • Common open load diagnostic • Common thermal shutdown and overload diagnostic • Per channel thermal shutdown diagnostic • Designed to meet IEC 61131-2 • Miniaturized HTSSOP20 package Applications • Programmable logic control • Industrial PC peripheral input/output • Numerical control machines • General low-side switch applications Description The IPS4260L is a monolithic high speed (FSW up to 250 kHz) device, which can drive four independent capacitive, resistive or inductive loads with one side connected to supply voltage. The channels can be parallelized to reduce power dissipation. When connected to Vcc rail, four integrated catch diodes clamp the turn-off transients generated by inductive loads even with huge inductance; combined with proper external TVS connected to VCC or to GND the IC allows fast decay, too. Each channel is protected against overload or short circuit event: the intervention level can be set by an external resistor on ILIM pin . DS12305 - Rev 3 - April 2020 For further information contact your local STMicroelectronics sales office. www.st.com IPS4260L Built-in thermal shutdown protects the chip against overtemperature even in case of short-circuit. If enabled, the integrated cut-off protection features a non-dissipative protection in case of overload; it limits both the output average current value and, consequently, the device overheating. Cut-off delay/restart can be programmed by external resistors on CoD pin; it can be disabled by shorting CoD to GND. Two common diagnostic open drains pins (OL, for open load and FLT for cut-off and thermal shutdown) together with the four open drain on each INx pin (cut-off and thermal shutdown) feature an extensive diagnostic of the chip. DS12305 - Rev 3 page 2/28 IPS4260L Block diagram 1 Block diagram Figure 1. Block diagram VCC UVLO VCLAMP IN1 VZ LOAD1 IN2 GATE IN3 DRIVERS LOGIC IN4 INTERFACE LOAD2 LOAD3 LOAD4 OL FLT SGND CURRENT LIMITATION CUT-OFF THERMAL JUNCTION.


A4919 IPS4260L SN74AXC4T245


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site.
(Privacy Policy & Contact)