Hot Swappable 2-Wire Bus Buffer
U U
FEATURES
■ Automatic Disconnect of SDA/SCL Lines when Bus
is Stuck Low for ≥30ms
■ Fault Flag for Stuck Bus
■ R...
Description
U U
FEATURES
■ Automatic Disconnect of SDA/SCL Lines when Bus
is Stuck Low for ≥30ms
■ Fault Flag for Stuck Bus
■ Recovers Stuck Busses with Automatic Clocking*
■ Bidirectional Buffer* for SDA and SCL Lines
Increases Fanout
■ Prevents SDA and SCL Corruption During Live
Board Insertion and Removal from Backplane
■ Allows Bus Pullup Voltages Above and Below VCC ■ ±15kV Human Body Model ESD Protection
■ Isolates Input SDA and SCL Lines from Output ■ Compatible with I2CTM, I2C Fast-Mode and SMBus
Standards (Up to 400kHz Operation)
■ READY Open Drain Output
■ 1V Precharge on All SDA and SCL Lines
■ High Impedance SDA, SCL Pins for VCC = 0V ■ ENABLE Gates Connection from Input to Output
■
MSOP
10-Pin
and DFN
U
(3mm
×
3mm)
Packages
APPLICATIO S
■ Hot Board Insertion ■ Servers ■ Capacitance Buffer/Bus Extender ■ RAID Systems
LTC4304
Hot Swappable 2-Wire Bus Buffer with Stuck Bus Recovery
DESCRIPTIO
The LTC®4304 hot swappable 2-wire bus buffer allows I/O card insertion into a live backplane without corruption of the data and clock busses. When a connection is made, the LTC4304 provides bidirectional buffering, keeping the backplane and card capacitances isolated. If SDAOUT or SCLOUT is low for ≥30ms (typ), the LTC4304 automatically breaks the data and clock bus connection and FAULT will pull low. At this time the LTC4304 automatically generates up to 16 clock pulses on SCLOUT in an attempt to free the bus. A connection will be enabled automatically when the b...
Similar Datasheet