AC Contactors
Contactor
Instructions
3TF30, 3TF31
DIN VDE 0660, IEC 60947
Order No.: 3ZX1012>0TF00>1AA2
! Limited protection against...
Description
Contactor
Instructions
3TF30, 3TF31
DIN VDE 0660, IEC 60947
Order No.: 3ZX1012>0TF00>1AA2
! Limited protection against contact with live parts
Degree of protection IP 20 to IEC 60529 Safe from finger touch to DIN VDE 0106, Part 100 Commissioning and maintenance by qualified personnel only. Follow the operating instructions.
Cleaning Remove dust by suction.
Auxiliary contact block For replacement see Fig. V.
WARNING:
HAZARDOUS VOLTAGE CAN CAUSE ELECTRICAL SHOCK
AND BURNS. DISCONNECT POWER BEFORE PROCEEDING
WITH ANY WORK ON THIS EQUIPMENT.
Installation
For dimension drawings (dimensions in mm) see
> Fig. I a > Fig. I b
a.c. operated d.c. operated
1) Minimum clearances from earthed parts Snap onto 35 mm standard mounting rail to DIN EN 50 022 or fix on a plain surface with two M4 screws. With screw mounting, always use plain washers and spring washers.
Cover the contactors during installation if foreign particles, such as swarf, can fall onto them. Install contactors in a housing if they are exposed to dirt, dust or aggressive atmospheres.
For permissible mounting positions see > Fig. II a a.c. operated > Fig. II b d.c. operated
Connection
The terminal screws can be tightened with a power screwdriver. Screwdriver blade width: 5 to 6 mm
Permissible cross>sections for main and auxiliary conductors :
Solid Finely stranded, with end sleeve
2¥0.5 to 1 mm2 2¥1 to 2.5 mm2 1¥4 mm2 2¥0.75 to 2.5 mm2
AWG wires
2¥AWG 18 to 12
Tightening torque standard type
0.8to 1.4 Nm/...
Similar Datasheet