16 Mbit LPC Flash
16 Mbit LPC Flash
SST49LF160C
FEATURES:
160C16Mb LPC Flash
Advance Information
• Organized as 2M x8
• Conforms to LP...
Description
16 Mbit LPC Flash
SST49LF160C
FEATURES:
160C16Mb LPC Flash
Advance Information
Organized as 2M x8
Conforms to LPC Interface Specification
– Support Single-Byte LPC Memory Read/Write Cycles
Single 3.0-3.6V Read and Write Operations
LPC Mode
– 5-signal LPC bus interface for both in-system and factory programming using programmer equipment
– 33 MHz clock frequency operation – WP#/AAI and TBL# pins provide hardware Write
protect for entire chip and/or top Boot Block – Block Locking Registers for individual block Read-
Lock, Write-Lock, and Lock-Down protection – 5 GPI pins for system design flexibility – 4 ID pins for multi-chip selection – Status register for End-of-Write detection – Program-/Erase-Suspend
Read or Write to other blocks during Program-/Erase-Suspend
Two-cycle Command Set
Security ID Feature
– 256-bit Secure ID space - 64-bit Unique Factory Pre-programmed Device Identifier - 192-bit User-Programmable OTP
Superior Reliability
– Endurance: 100,000 Cycles (typical) – Greater than 100 years Data Retention
Low Power Consumption
– Active Read Current: 12 mA (typical) – Standby Current: 10 µA (typical)
Uniform 4 KByte sectors
– 35 Overlay Blocks: one 16-KByte Boot Block, two 8-KByte Parameter Blocks, one 32-Kbyte Parameter Block, thirty-one 64-KByte Main Blocks.
Fast Sector-Erase/Program Operation
– Sector-Erase Time: 18 ms (typical) – Block-Erase Time: 18 ms (typical) – Program Time: 7 µs (typical)
Auto Address Increment (AAI) for Rapid Factor...
Similar Datasheet