Soft-Start Controlled Load Switch
NCP330
Soft-Start Controlled Load Switch
The NCP330 is a low Ron N−channel MOSFET controlled by a soft−start sequence o...
Description
NCP330
Soft-Start Controlled Load Switch
The NCP330 is a low Ron N−channel MOSFET controlled by a soft−start sequence of 2 ms for mobile applications.
The very low RDS(on) allows system supplying or battery charging up to DC 3A.The device is enable automatically if a Power Supply is connected on Vin pin (active High) and maintained off if no Vin (internal pull down).
Due to a current consumption optimization, leakage current is drastically decreased from the battery connected to the device, allowing long battery life.
Features
1.8 V − 5.5 V Operating Range 30 mW N−MOSFET DC Current Up to 3 A Peak Current Up to 5 A Built−in Soft−Start 2 ms Reverse Voltage Protection Active High with Integrated Bridge Compliance to IEC61000−4−2 (Level 4)
8.0 kV (Contact) 15 kV (Air)
ESD Ratings: Machine Model = B
Human Body Model = 3
mDFN4 1.2 x 1.6 mm NCV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100 Qualified and PPAP Capable
This is a Pb−Free Device
Typical Applications
Mobile Phones Tablets Digital Cameras GPS Computers
Vbat
1 mF
IN OUT NCP330
1 mF
EN GND EN
www.onsemi.com
1
UDFN4 CASE 517CE
MARKING DIAGRAM
3A M
3A = Specific Device Code M = Date Code
PINOUT DIAGRAM
IN GND
PAD1
OUT EN
(Top View)
ORDERING INFORMATION
See detailed ordering and shipping information on page 8 of this data sheet.
VBUS USB D+ Port D−
GND
4
IN CMIC OUT
Supply HS Monitoring USB
I@C Signal Routing
Acces...
Similar Datasheet