MLC852A 8-Bit micro-controller with 1120 dots LCD driver
Features
• Single chip 8-bit micro-controller • Operating volt...
MLC852A 8-Bit micro-controller with 1120 dots LCD driver
Features
Single chip 8-bit micro-controller Operating voltage: 2.4V to 5.5V Memory :
♦ Program ROM: 64K Bytes ♦ Data RAM (stack RAM included) : 3328
Bytes (0000h ~ 0CFFh) ♦ LCD RAM : 144 Bytes
20 input/output pins:
♦ Dedicated I/O pins: P0[0:3] ♦ Share pin I/O:
! P0[4]/SEG[69] ! P0[5:7]/SEG[66:64] ! P1[0:1]/UART(TX, RX) ! P2[0:7]/SEG[63:56] ! P3[0:1]/SEG[68:67]/(SDIO, SCLK)
Half duplex UART function Build-in Megawin e-flash interface Dedicated SPK pin for tone/DAC LCD driver output:
♦ Max 70 segment × 16 common ♦ 1/16 duty 1/5 bias driving mode ♦ Build-in voltage
regulator and pumper
to generate LCD voltage for LCD driver
♦ 10 level programmable frame rate from 56.7Hz to 113.8Hz
♦ 16-level adjustable VLCD from 3.5 V to 5.75 V
One 8-bit resolution DAC output Programmable sample rate for
voice/melody function
Two reloadable 8-bit timers Two dividers
One 14-bit divider with the clock source from sub-oscillator to generate a 2-Hz interrupt
One 7-bit divider with the clock source from main oscillator
Build-in dual oscillation circuit:
♦ Ring oscillator up to 5MHz at 3.6V – 5.5V 4MHZ at 2.4V – 3.4V for main oscillator (Fosc)
♦ 32768Hz crystal oscillator for sub-oscillator (Fx32)
Build-in 8-level battery-low detector circuit
This document contains information on a new product under development by MEGAWIN. MEGAWIN reserves the right to change or discontinue
this product without notice.
MEGAWIN...