Document
CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS
CV Chip Type, High Voltage / Long Life series
High voltage (to 63V), Low ESR, High ripple current. Load life of 3000 hours at 105°C. SMD type : Lead free reflow soldering condition at 260°C peak correspondence. Compliant to the RoHS directive (2002/95/EC).
CV
CFHigh Voltage Long Life
Specifications
Item
Performance Characteristics
Category Temperature Range – 55 to +105°C
Rated Voltage Range
16 to 63V
Rated Capacitance Range 5.6 to 470µF
Capacitance Tolerance
± 20% at 120Hz, 20°C
Tangent of loss angle (tan δ) Less than or equal to the specified value at 120Hz, 20°C
ESR ( 1)
Less than or equal to the specified value at 100kHz, 20°C
Leakage Current ( 2) Less than or equal to the specified value . After 2 minutes' application of rated voltage at 20°C
Temperature Characteristics (Max.Impedance Ratio)
Z+105°C / Z+20°C 1.25 Z– 55°C / Z+20°C 1.25
(100kHz)
Endurance
The specifications listed at right shall be met when the capacitors are restored to 20°C after the rated voltage is applied for 3000 hours at 105°C.
Capacitance change tan δ ESR ( 1) Leakage current ( 2)
Within ± 20% of the initial capacitance value ( 3) 150% or less than the initial specified value 150% or less than the initial specified value Less than or equal to the initial specified value
Damp Heat (Steady State)
The specifications listed at right shall be met when the capacitors are restored to 20°C after the rated voltage is applied for 1000 hours at 60°C, 90% RH.
Capacitance change tan δ ESR ( 1) Leakage current ( 2)
Within ± 20% of the initial capacitance value ( 3) 150% or less than the initial specified value 150% or less than the initial specified value Less than or equal to the initial specified value
Resistance to Soldering Heat
Marking
After soldering the capacitor under the soldering conditions prescribed here, the capacitor shall meet the specifications listed at right, provided that it's temperature profile is measured at the capacitor top and the terminal. Pre-heating shall be done at 150 to 200°C and for 60 to 180 sec. The duration for over +230°C temperature at capacitor surface shall not exceed 60 seconds. In the case of peak temp, less than 250°C, reflow soldering shall be two times maximum. In the case of peak temp, less than 260°C, reflow soldering shall be once. Measurement for solder temperature profile shall be made at the capacitor top and the terminal.
Navy blue print on the case top
Capacitance change tan δ ESR ( 1) Leakage current ( 2)
Within ± 10% of the initial capacitance value ( 3) 130% or less than the initial specified value 130% or less than the initial specified value Less than or equal to the initial specified value
1 ESR should be measured at both of the terminal ends closest where the terminals protrude through the plastic platform. 2 Conditioning : If any doubt arises, measure the leakage current after the voltage treatment of applying DC rated voltage continuously to the capacitor for 120
minutes at 105°C. 3 Initial value : The value before test of examination of resistance to soldering.
Dimensions
Capacitance
Lot No.
Plastic platform 0.3 MAX.
C±0.2
Positive
0.5 MAX.
E A ± 0.2
B± 0.2
CV 82 V 012 φD + 0.5 MAX.
Series
Voltage (V:35V)
L
+0.1 - 0.4
Negative H
Type numbering system (Example : 35V 82µF)
1 2 3 4 5 6 7 8 9 10 11 12 13 14
PCV 1 V 8 2 0 MC L 1 GS
Taping code Size code
Configuration Capacitance toleranc (±20%)
Rated capacitance (82µF) Rated voltage (35V) Series name Type
(mm)
Size φ6.3 × 6L φ8 × 7L φ8 × 10L φ8 × 12L φ10 × 8L φ10 × 10L φ10×12.7L
φD 6.3 8.0 8.0 8.0 10.0 10.0 10.0
L 5.9 6.9 9.9 11.9 7.9 9.9 12.6
A 7.3 9.0 9.0 9.0 11.0 11.0 11.0
B 6.6 8.3 8.3 8.3 10.3 10.3 10.3 Voltage
C 6.6 8.3 8.3 8.3 10.3 10.3 10.3 E 2.1 3.2 3.2 3.2 4.6 4.6 4.6
V 16 20 25 35 50 63
H 0.5 to 0.8 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 0.8 to 1.1 Code C D E V H J
Dimension table in next page.
CAT.8100Z
CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS
CVseries
Standard Ratings
Rated Voltage Surge Voltage Rated Capacitance
(V)(code)
(V)
(µF)
56
100
16 (1C)
18.4
220 220 270
330
470
47
68
20 (1D)
23.0
150 150 220
270
330
33
56
25 (1E)
28.7
120 120 150
180
270
18
27
35 (1V)
40.2
56 68 82
100
150
8.2
15
50 (1H)
57.5
33 33 39
47
68
5.6
10
63 (1J)
72.4
22 22 27
33
47
Case Size φD × L (mm)
6.3 × 6 8×7 8 × 10
10 × 8 8 × 12
10 × 10 10 × 12.7 6.3 × 6
8×7 8 × 10 10 × 8 8 × 12 10 × 10 10 × 12.7 6.3 × 6 8 ×7 8 × 10 10 × 8 8 × 12 10 × 10 10 × 12.7 6.3 × 6 8 ×7 8 × 10 10 × 8 8 × 12 10 × 10 10 × 12.7 6.3 × 6 8 ×7 8 × 10 10 × 8 8 × 12 10 × 10 10 × 12.7 6.3 × 6 8 ×7 8 × 10 10 × 8 8 × 12 10 × 10 10 × 12.7
tan δ
0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12 0.12
Leakage Current
ESR (mΩ)
(µA) (at 1.