EUP2471

EUP2471 1.5A Dual WLED Flash Driver with I2C Compatible Interface DESCRIPTION The EUP2471 is a 2MHz fixed frequency, current mode synchronous boost converter. The device is designed to operate as a dual 750mA (1.5A total) constant current driver for flash white LED application. An industry-standard I2C serial digital input is used to enable, disable and set the movie-mode current for each flash LED with up to 16 movie-mode settings. The EUP2471 also includes a separate Flash Enable input to initiate both the flash operation and the default timer, which can be used either to terminate a flash event at the end of a user-programmed delay or as a safety feature. The maximum flash and movie-mode current is set by one external resistor; the ratio of Flash to Movie-mode current is set at approximately 6.1:1. An over-voltage protection feature keeps the output voltage below the OVP threshold in case of an open LED and an output short circuit protection limits the output current during an output short to GND. The chip’s quiescent current is less than 1.0µA in shutdown mode. FEATUES 2.7V to 5.5V Input Supply Range Dual Channel Output with Separate Flash Enable Up to 1.5A Regulated Output Current (750mA per channel) Up to 85% Efficiency 2 MHz Fixed Switching Frequency I2C Compliant Serial Interface - 400kHz Serial Transfer Rate -16 Level Movie-mode Current -Flash/Movie-mode -Programmable LED Current -Programmable Flash Safety Timer True Load Disconnect Input Current Limit Output Over-V...