16K SPI Bus Serial EEPROM
Not recommended for new designs – Please use 25AA160A/B or 25LC160A/B.
25AA160/25LC160/25C160
16K SPI Bus Serial EEPROM...
Description
Not recommended for new designs – Please use 25AA160A/B or 25LC160A/B.
25AA160/25LC160/25C160
16K SPI Bus Serial EEPROM
Device Selection Table
Part Number
25AA160 25LC160 25C160
VCC Range
1.8-5.5V 2.5-5.5V 4.5-5.5V
Max Clock Frequency
1 MHz 2 MHz 3 MHz
Temp Ranges
I I I,E
Features:
Low-power CMOS technology: - Write current: 3 mA maximum - Read current: 500 A typical - Standby current: 500 nA typical
2048 x 8-bit organization 16 byte page Write cycle time: 5 ms max. Self-timed erase and write cycles Block write protection:
- Protect none, 1/4, 1/2 or all of array Built-in write protection:
- Power on/off data protection circuitry - Write enable latch - Write-protect pin Sequential read High reliability: - Endurance: 1 M cycles - Data retention: > 200 years - ESD protection: > 4000V 8-pin PDIP and SOIC packages Temperature ranges supported:
- Industrial (I):
-40C to +85C
- Automotive (E) (25C160): -40°C to +125°C
Description:
The Microchip Technology Inc. 25AA160/25LC160/ 25C160 (25XX160*) are 16 Kbit Serial Electrically Erasable PROMs. The memory is accessed via a simple Serial Peripheral Interface (SPI) compatible serial bus. The bus signals required are a clock input (SCK) plus separate data in (SI) and data out (SO) lines. Access to the device is controlled through a Chip Select (CS) input.
Communication to the device can be paused via the hold pin (HOLD). While the device is paused, transitions on its inputs will be ignored, with the e...
Similar Datasheet