IS25CD512

IS25CD512/010 & IS25LD020 512Kbit/1 Mbit / 2 Mbit Single Operating Voltage Serial Flash Memory With 100 MHz Dual-Output SPI Bus Interface Output SPI Bus Interface FEATURES Low Power Consumption Memory With 100 MHz Dual Single Power Supply Operation - Typical 10Memory mA active read current Output SPI Bus Interface With 100 MHz Dual- Low voltage range: 2.70 V – 3.60 V (512Kbit / 1Mbit) - Typical 15 mA program/erase current Output SPI Bus Interface 2.30 V – 3.60 V (2Mbit) Memory Organization - IS25CD512: 64K x 8 (512 Kbit) - IS25CD010: 128K x 8 (1 Mbit) - IS25LD020: 256K x 8 (2 Mbit) Cost Effective Sector/Block Architecture - 512Kb : Uniform 4KByte sectors / Two uniform 32KByte blocks - 1Mb : Uniform 4KByte sectors / Four uniform 32KByte blocks - 2Mb : Uniform 4KByte sectors / Four uniform 64KByte blocks Low standby current 1uA (Typ) Serial Peripheral Interface (SPI) Compatible - Supports single- or dual-output - Supports SPI Modes 0 and 3 - Maximum 33 MHz clock rate for normal read - Maximum 100 MHz clock rate for fast read Page Program (up to 256 Bytes) Operation - Typical 2 ms per page program Sector, Block or Chip Erase Operation - Maximum 10 ms sector, block or chip erase Hardware Write Protection - Protect and unprotect the device from write operation by Write Protect (WP#) Pin Software Write Protection - The Block Protect (BP2, BP1, BP0) bits allow partial or entire memory to be configured as read-only High Product Endurance - Guaranteed 200,000 prog...