ST040

Scanner-Driver ST040/050 30.48 6 x 5.08 Description 9 10 11 12 Signal Amplitude Trimmer DC-Offset Amplitude Trimmer Intern Gain Trimmer Damping Trimmer Drive Board Operating Voltage +/- 20 VDC unstabilized 12 100.00 or 30 VAC +/- 2,5 Amp. Fuse: Scanner Driver T 3,15 A Center Tapped 10 11 Input Signal: U max. +/- 10 V input Signal DC-Offset: U max. +/- 10 V 9 Weight: 300 g Input Signal DC-Offset: U max. +/- 10 V Scanner Output Connector fem. 15 Pin D-Sub IEC 48B Scanner Driver Connector male 32 Pin DIN 41612 Drive Coil (low) Shield Drive Coil (high) transp. 1/9 2/10 Shield Input Signal max.+/- 10V Cable 1 c a 2 4 6 8 10 12 Input DC-Offset max. +/- 10 V DC-Supply -20 VDC (unstabilized) GND +20 VDC (unstabilized) AC-Supply 15 VAC Center Tapped 15 VAC Ground Shield FB-Supply red 4 8 Shield 14 16 18 20 22 Cable 2 Position Sign. (-) blue Position Sign. (+) transp. 11 3 24 26 28 30 32 Feedback Signal Output i- 4051 subject to change 0 4.6.13 Laser Scanning Keiser AG obere Aegerten 12 CH-8143 Stallikon Free Datasheet http://www.Datasheet4U.com Scanner-Driver ST040/050 16 3,15AT 17 12 LSK AG 10 normal 11 Connector 32 Pin DIN 41612 m 18 9 31 invers 19 20 26 27 28 30 29 adjustment 31 Description 16 17 18 19 20 26 27 28 29 30 31 20 Fuse Drive Coils Output T 3,15 A 5 x 20 mm Current Measure Resistor (according to list) Trimmer I-Factor Trimmer Feedback Signal Offset Adjust (trimmed by manufacturer - don t screw) Trimmer Driver Offset Adjust Tr...