DatasheetsPDF.com

PN65K Dataheets PDF



Part Number PN65K
Manufacturers NXP
Logo NXP
Description Near Field Communication (NFC) SmartConnect Module
Datasheet PN65K DatasheetPN65K Datasheet (PDF)

PN65K Near Field Communication (NFC) SmartConnect Module in a single package Rev. 1.3 — 20 October 2006 Objective short data sheet 1. General description PN65K combines in a single package a Near Field Communication (NFC) controller PN531 and a Secure Smart Card controller. They are tied together by the means of external connections for the S2C interface and the PN531 is supplying the Smart card controller by the means of a specific internal regulator. The embedded PN531 firmware drives the suppl.

  PN65K   PN65K


Document
PN65K Near Field Communication (NFC) SmartConnect Module in a single package Rev. 1.3 — 20 October 2006 Objective short data sheet 1. General description PN65K combines in a single package a Near Field Communication (NFC) controller PN531 and a Secure Smart Card controller. They are tied together by the means of external connections for the S2C interface and the PN531 is supplying the Smart card controller by the means of a specific internal regulator. The embedded PN531 firmware drives the supply to the SmartMX device when required in order to optimize the overall current consumption of the SmartConnect device. The PN65K can behave as an NFC initiator, working in active or passive mode and when operating in passive mode it can operate as a reader/writer for Mifare or FeliCa contactless smart cards. The Peer to peer functionality is also supported in both active and passive modes. The PN65K can also operate as a card mode and specially when the combined SmartMX device is enabled it can operate as a pure Mifare card or as a fully compliant ISO14443A 3&4 contactless smart card. 1.1 Naming conventions P65xyy(y)z PN65 x yy(y) z Example: PN65KHN1 K: module with PN531, HN: HVQFN package, 1: pure MCM version SmartConnect Module SmartConnect module based on the Smard Card IC P5CNaabb plus NFC IC defines the NFC IC Pn5xx, e.g. A for PN511, B for PN512, K for PN531, L for PN532 Package Type: HN for HVQFN Optional parameter for discrete components in the integrated in the MCM or version identification Free Datasheet http://www.Datasheet4U.com NXP Semiconductors PN65K Near Field Communication (NFC) SmartConnect Module in a single package 2. Features 2.1 General s SmartConnect module integrating NFC controller PN531 device and SmartMX (P5CN072) secure smart card controller in a single package. s Single package solution for size optimization; needs external antenna matching circuitry, uncoupling capacitors and crystal oscillator. s Fully NFC IP-1 (ISO18092) compliant 2.2 NFC controller s 80C51 microcontroller core with 32 Kbyte ROM and 1 Kbyte RAM s Highly integrated analog circuitry to demodulate and decode responses s Buffered output drivers to connect an antenna with minimum number of external components s Integrated RF Level detector s Integrated data mode detector s Supports ISO 14443A/Mifare s Typical operating distance in reader/writer mode for communication to a ISO 14443A/Mifare or FeliCa card up to 50 mm depending on the antenna size and tuning s Typical operating distance in NFCIP-1 mode up to 50 mm depending on the antenna size and tuning and power supply s Typical operating distance in ISO 14443A/Mifare card or FeliCa card interface mode of about 100 mm depending on the antenna size and tuning and the external field strength s Supports Mifare Classic encryption in reader/writer mode and Mifare higher transfer speed communication at 212 kbit/s and 424 kbit/s s Supports contactless communication according to the FeliCa scheme at 212 kBaud and 424 kBaud s Integrated RF interface for NFCIP-1 up to 424 kBaud s Possibility to communicate on the RF interface above 424 kBaud using external analog circuitry s Supported host interfaces x SPI interface x I2C interface x High Speed Serial UART (similar to RS232 with 0 and PVDD voltage levels) s Flexible interrupt using IRQ pin s Hard reset with low power function s Power-down mode per embedded firmware s Programmable timer s Internal oscillator to connect 27.12 MHz crystal s 3.3 V power supply when not USB bus powered s Power Switch for external secure component s Specific IO ports for external devices control 111113 © NXP B.V. 2006. All rights reserved. Objective short data sheet Rev. 1.3 — 20 October 2006 2 of 15 Free Datasheet http://www.Datasheet4U.com NXP Semiconductors PN65K Near Field Communication (NFC) SmartConnect Module in a single package 2.3 Secure smart card controller The device used in this module is the P5CN072 Secure Dual Interface PKI Smart Card Controller which has the following features: s 72 Kbytes EEPROM s 160 Kbytes User ROM s 4608 bytes RAM s PKI (Public Key Infrastructure) co-processor s Dual Triple DES Key co-processor s S2C interface to enable secure contact-less communication via NFC (Near Field Communication) s EEPROM data retention time: 20 years minimum The P5CN072 is a Secure Dual interface PKI Smart Card Controller of the SmartMX platform featuring 160 Kbytes of user ROM, 4608 bytes of RAM and 72 Kbytes of EEPROM which can be used as data memory or as program memory.The non-volatile memory consists of high reliability memory cells to guaranty data integrity which is important especially when EEPROM memory is used as program memory. Operated both in contact mode (ISO IEC 7816) or S2C mode, the user defines the final function of the chip with his chip operating system (COS). This allows the same level of security, functionality and flexibility for the contact interface as well for the S2C interface. The S2C technology provides reliab.


SIHFZ48 PN65K LM222-170EG01


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site.
(Privacy Policy & Contact)