(SPO15 / SPO18) Installation Instructions
Sprinter SPO15 (3A0 Lifts) Capacity 11,000 lbs. Standard SPO15 (300 Series Lifts) Capacity 15,000 lbs. Standard SPO18 (3...
Description
Sprinter SPO15 (3A0 Lifts) Capacity 11,000 lbs. Standard SPO15 (300 Series Lifts) Capacity 15,000 lbs. Standard SPO18 (300 Series Lifts) Capacity 18,000 lbs.
SPO15, SPO18
I I N N S S T T A A L L L L A A T T I I O O N N I I N N S S T T R R U U C C T T I I O O N N S S
Free Datasheet http://www.datasheet4u.net/
LP20293
© September 2007 by Rotary Lift. All rights reserved. CO6953.6 Rev. C 09/12/2007
IN20379
Wheel Spotting Dishes
7''– 6" Min. To Nearest Obstruction 15'– 0" Min. To Nearest Obstruction Power Unit to Passenger Side
19 1/4" 34" 6" (18) 3/4" Anchors 62 7/16" 28" Front
C L
Lift 900
900
Alignment Notches
15'– 0" Min. To Nearest Obstruction
APPROACH
Rear
12' - 11"
Fig. 1
1. Lift Location: Use architects plan when available to locate lift. Fig. 1 shows dimensions of a typical bay layout. 2. Lift Height: See Fig. 4 for overall lift height of each specific lift model. Add 1” min. to overall height to lowest obstruction.
Drill (18) 3/4" dia. holes in concrete floor using holes in column base plate as a guide. See diagrams for hole depth, hole spacing, and edge distance requirements.
C
C
C
B
WARNING DO NOT install this lift in a pit or depression due to fire or explosion risks.
3. Lift Setting: Position columns in bay using dimensions shown in Fig.1. Place column with power unit mounting bracket on vehicle passenger side of lift. Both column base plate backs must be square on center line of lift. Notches are cut into each base plate to indicate center line o...
Similar Datasheet