extension cable between USB device and host
1 26 Oct 2006 – Ver. 1.1 Preliminary UIC4102CP USB 1.1 Active Extension Cable
Description
This device is an extension c...
Description
1 26 Oct 2006 – Ver. 1.1 Preliminary UIC4102CP USB 1.1 Active Extension Cable
Description
This device is an extension cable between USB device and host (computer) with embedded into connector “intelligent” integrated circuits on both sides of the cable. The USB cable with the chip inside is not a passive extension cable. It is an active device. The USB signals going in and out of this extension cable in both directions are buffered to assure signal quality. Unlike passive USB cables the IC prevents signal degradation. The embedded “intelligent” integrated circuit cleans, amplifies USB signal and watches USB 1.1 protocol. Its Control State Machine enables and disables USB and Cable transmitters inside the chip depending on USB signals.
Features
♦ Compliant with USB 1.1 specification; ♦ Provides support for any full-speed (12 Mb/s) or low-speed (1.5 Mb/s) USB device; ♦ Allows a USB device to have its cable length extended up to 30 meters; ♦ Embedded USB 1.1 Transceivers prevents signal loss; ♦ Low cost in comparison with extension of cable using Hubs; ♦ Power (vcc) and ground (gnd) Wire Size: 20 AWG; ♦ USB Signal lines (DP and DM) Wire Size: 28 AWG, Stranded-Twisted Pair, 90 Ohm Characteristic Impedance; ♦ Downstream connector: Female, Type “A”, USB Approved Connector; ♦ Upstream connector: Male, Type “A”, USB Approved Connector;
Free Datasheet http://www.datasheet4u.com/
2 26 Oct 2006 – Ver. 1.1 Preliminary UIC4102CP USB 1.1 Active Extension Cable
Compatibility
The UIC410...
Similar Datasheet