MDT10P73BB

MDT10P73(BB) 1. General Description This EPROM-Based 8-bit micro-controller uses a fully static CMOS technology process to achieve higher speed and smaller size with the low power -CCP1, CCP2, SCM, USAR, USAT A/D converter module: -5 analog inputs multiplexed into one A/D converter -8 bit resolution TMR0: 8-bit timer/counter TMR1: 16-bit timer/counter TMR2: 8-bit timer 4 types of oscillator can be selected by consumption and high noise immunity. On chip memory includes 4K words of ROM, and 192 bytes of static RAM. 2. Features The followings are some of the features on the hardware and software : Fully CMOS static design 8-bit data bus On chip EPROM size: 4.0 K words Internal RAM size: 192 bytes 37 single word instructions 14-bit instructions 8-level stacks Operating voltage: 2.5 V ~ 5.5 V (PRD Disable) 4.5 V ~ 5.5 V (PRD Enable) Operating frequency: DC ~ 20 MHz The most fast execution time is 200 ns under 20 MHz in all single cycle instructions except the branch instruction Addressing modes include direct, indirect and relative addressing modes Power-on Reset Power edge-detector Reset Power range-detector Reset Sleep Mode for power saving Capture, Compare, PWM module Synchronous serial port with SCM 11 interrupt sources: -External INT pin -TMR0 timer, TMR1 timer, TMR2 timer -A/D conversion completion -Port B<7:4> interrupt on change programming option: RC－Low cost RC oscillator LFXT－Low frequency crystal oscillator XTAL－Standard crystal oscillator HFXT－High frequency cryst...