LGER433.92M(TO-39)
SAW resonator
1. SCOPE
This specification shall cover the characteristics of 1-port SAW resonator wi...
LGER433.92M(TO-39)
SAW resonator
1. SCOPE
This specification shall cover the characteristics of 1-port SAW resonator with used for remote-control security.
2. ELECTRICAL SPECIFICATION
DC Voltage VDC AC Voltage Vpp Operation temperature Storage temperature RF Power Dissipation Electronic Characteristics
Item Center Frequency Insertion Loss Quality Factor Unload Q 50Ω Loaded Q Temperature Turnover Temperature Stability Turnover Frequency Freq.temp.Coefficient Frequency Aging DC. Insulation Resistance
Motional Resistance RM
10V 10V50Hz/60Hz -20℃ to +85℃ -45℃ to +85℃ 0dBm
Unites MHz dB
Minimum 433.845
Typical 433.920 1.5 12,800 2,000
Maximum 433.995 2.5
℃ KHz ppm/℃2 ppm/yr MΩ Ω μH pF pF pF
20
35 fo±1.3 0.032 <±10
50
1.0 18 86 1.5 1.7 2.0 1.9 2.3 26
RF Equivalent Motional Inductance LM RLC Model Motional Capacitance CM Pin 1 to Pin 2 Staic Capacitance Co Transducer Static Capacitance Cp
3. TEST CIRCUIT
http://www.luguang.cn
mail:
[email protected]
Free Datasheet http://www.datasheet4u.com/
LGER433.92M(TO-39)
SAW resonator
4.EQUIVALENT LC MODEL The following equivalent LC model is Valid near resonance
5. DIMENSION
6. ENVIRONMENTAL CHARACTERISTICS
6-1 High temperature exposure Subject the device to +85℃ for 16 hours. Then release the filter into the room conditions for 24 hours prior to the measurement. It shall fulfill the specifications in table 1. 6-2 Low temperature exposure Subject the device to -20℃ for 16 hours. Then release the device into the room conditions...