VND600SP-E

www.DataSheet4U.com VND600SP-E DOUBLE CHANNEL HIGH SIDE DRIVER Table 1. General Features Type VND600SP-E RDS(on) 30 mΩ Figure 1. Package Ilim 25 A VCC 36 V s s s DC SHORT CIRCUIT CURRENT: 25 A CMOS COMPATIBLE INPUTS PROPORTIONAL LOAD CURRENT SENSE s UNDERVOLTAGE AND OVERVOLTAGE n SHUT-DOWN s OVERVOLTAGE CLAMP s THERMAL SHUT DOWN s CURRENT LIMITATION s VERY LOW STAND-BY POWER DISSIPATION s PROTECTION AGAINST: n LOSS OF GROUND AND LOSS OF VCC s REVERSE BATTERY PROTECTION (*) s IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE DESCRIPTION The VND600SP-E is a monolithic device made using STMicroelectronics VIPower M0-3 technology. It is intended for driving resistive or inductive loads with one side connected to ground. Active V CC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table). 10 1 PowerSO-10 ™ This device has two channels in high side configuration; each channel has an analog sense output on which the sensing current is proportional (according to a known ratio) to the corresponding load current. Built-in thermal shut-down and outputs current limitation protect the chip from over temperature and short circuit. Device turns off in case of ground pin disconnection. Table 2. Order Codes Package PowerSO-10™ Note: (*) See application schematic at page 9 Tube VND600SP-E Tape and Reel VND600SPTR-E Rev. 1 October 2004 1/18 VND600SP-E Figure 2. Block Diagram www.DataSheet4U.com VCC OVERVOLTAGE VCC CLAMP UN...