single channel 85 W/1 W class-D power amplifier
TDF8599B
I2C-bus controlled dual channel 43 W/4 Ω, single channel 85 W/1 Ω class-D power amplifier with load diagnostics
...
Description
TDF8599B
I2C-bus controlled dual channel 43 W/4 Ω, single channel 85 W/1 Ω class-D power amplifier with load diagnostics
Rev. 01 — 29 July 2009 Product data sheet
1. General description
The TDF8599B is a dual Bridge-Tied Load (BTL) car audio amplifier comprising an NDMOST-NDMOST output stage based on SOI BCDMOS technology. Low power dissipation enables the TDF8599B high-efficiency, class-D amplifier to be used with a smaller heat sink than those normally used with standard class-AB amplifiers.
www.DataSheet4U.com
The TDF8599B can operate in either non-I2C-bus mode or I2C-bus mode. When in I2C-bus mode, DC load detection results and fault conditions can be easily read back from the device. Up to 15 I2C-bus addresses can be selected depending on the value of the external resistor connected to pins ADS and MOD. When pin ADS is short circuited to ground, the TDF8599B operates in non-I2C-bus mode. Switching between Operating mode and Mute mode in non-I2C-bus mode is only possible using pins EN and SEL_MUTE.
2. Features
I I I I I I I I I I I I I I I High-efficiency Low quiescent current Operating voltage from 8 V to 24 V Two 4 Ω/2 Ω capable BTL channels or one 1 Ω capable BTL channel Differential inputs I2C-bus mode with 15 I2C-bus addresses or non-I2C-bus mode operation Clip detect Independent short circuit protection for each channel Advanced short circuit protection for load, GND and supply Load dump protection Thermal foldback and thermal protection DC offset protection Selectable...
Similar Datasheet