ATSAM3S

Features Core – ARM® Cortex®-M3 revision 2.0 running at up to 64 MHz – Memory Protection Unit (MPU) – Thumb®-2 instruction set Pin-to-pin compatible with AT91SAM7S legacy products (48- and 64-pin versions) Memories – From 64 to 256 Kbytes embedded Flash, 128-bit wide access, memory accelerator, single plane – From 16 to 48 Kbytes embedded SRAM – 16 Kbytes ROM with embedded bootloader routines (UART, USB) and IAP routines – 8-bit Static Memory Controller (SMC): SRAM, PSRAM, NOR and NAND Flash support – Memory Protection Unit (MPU) System – Embedded voltage regulator for single supply operation – Power-on-Reset (POR), Brown-out Detector (BOD) and Watchdog for safe operation – Quartz or ceramic resonator oscillators: 3 to 20 MHz main power with Failure Detection and optional low power 32.768 kHz for RTC or device clock – High precision 8/12 MHz factory trimmed internal RC oscillator with 4 MHz default frequency for device startup. In-application trimming access for frequency adjustment – Slow Clock Internal RC oscillator as permanent low-power mode device clock – Two PLLs up to 130 MHz for device clock and for USB – Temperature Sensor – Up to 22 peripheral DMA (PDC) channels Low Power Modes – Sleep and Backup modes, down to 3 µA in Backup mode – Ultra low power RTC Peripherals – USB 2.0 Device: 12 Mbps, 2668 byte FIFO, up to 8 bidirectional Endpoints. On-Chip Transceiver – Up to 2 USARTs with ISO7816, IrDA®, RS-485, SPI, Manchester and Modem Mode – Two 2-wire UARTs –...