FDMS2380 Dual Integrated Solenoid Driver
August 2007
FDMS2380
Dual Integrated Solenoid Driver Features
5A, 60V Load ...
FDMS2380 Dual Integrated Solenoid Driver
August 2007
FDMS2380
Dual Integrated Solenoid Driver Features
5A, 60V Load Clamp rDS(ON) = 30mΩ (Typ.) Excitation path 6V to 26V Operation CMOS Compatible Soft Short Detection Thermal Shutdown Diagnostic Output Integrated Clamps Over-current Protection Open Load Detection Over-voltage Protection
Pin 1
General Description
The FDMS2380 is an intelligent low side driver with built in recirculation and demagnetization circuits designed specifically for driving inductive loads. The inputs are CMOS compatible. A separate diagnostic signal for each channel provides the system with an indication of the operation of the solenoid or the presence of a protection fault condition. Built-in Over-voltage, Over-current, Overtemperature circuits protect the device from these conditions. Additional diagnostic circuitry is included for detecting Open Load, Under-voltage and output ground fault conditions. The FDMS2380 contains two independent intelligent low side solenoid drivers.
Applications
Transmission Solenoid Driver Inductive Load Management
Power QFN
Internal Logical Block Diagram (One of two Identical Channels)
www.DataSheet4U.com
Volt
Regulator & Over / Under Voltage Detect Soft Short & Recirculation INA Control Logic INB Over Temp Shutdown
VBATT
PDMOS Driver & Clamp
Power PDMOS Recirculation Device
OUT Open Load Detect
Power NDMOS
DIAG Diagnostic Control & Pulse Generation
Over Current Shutdown
NDMOS Driv...