Digital Signal Processor
NJU26100 Series
www.DataSheet4U.com
NJU26100 Series Hardware Specification
■ General Description
This document describ...
Description
NJU26100 Series
www.DataSheet4U.com
NJU26100 Series Hardware Specification
■ General Description
This document describes the NJU26100 Series common hardware specifications. This document is applied to the NJU26101 up to the NJU26199. The individual function is described in the each data sheet. Please refer to the each data sheet to find the detail functions. The firmware commands are described in the each firmware document.
■Package
■ Hardware Specification
NJU26100
Series
24bit Fixed-point Digital Signal Processing Maximum System Clock Frequency : 38MHz Digital Audio Interface : 3 Input ports / 3 Output ports Master / Slave Mode Master Mode MCK :1/2 fclk, 1/3 fclk ex. MCK = 384Fs(1/2) or MCK = 256Fs(1/3) at fclk=768Fs Two kinds of micro computer interface I2C bus (standard-mode/100kbps) Serial interface (4 lines: clock, enable, input data, output data) Power Supply : 2.5V ( 3.3V Input tolerant ) Package : QFP32-R1
AD1/SDIN AD2/SSb
NJU26100 Series
DSP ARITHMETIC UNIT SERIAL AUDIO INTERFACE BCKO LRO SERIAL OUT 24-BIT x 24-BIT MULTIPLIER ALU SERIAL OUT SERIAL OUT SERIAL IN SDO0 SDO1 SDO2 SDI0 SDI1 SDI2 BCKI LRI
SCL/SCK
SDA/SDOUT
SERIAL HOST INTERFACE
PROGRAM CONTROL
RESETb MCK XI XO TIMING GENERATOR ADDRESS GENERATION UNIT
SERIAL IN SERIAL IN
DELAY RAM
DATA RAM
FIRMWARE ROM
GPIO AND CONFIGURATION INTERFACE
GPIO0 GPIO1
Ver.2005-02-24
-1-
NJU26100 Series
www.DataSheet4U.com
■ Pin Configuration
VDDR VDDR VDDC VDDC
7 1 8 1 7 9 1 6 0 2 5 1 2 4 ...
Similar Datasheet