Document
Data Sheet No. PD60259
ADVANCE INFORMATION
IRS2453D(S)PbF
www.DataSheet4U.com
SELF-OSCILLATING FULL-BRIDGE DRIVER IC
Features
Integrated 600V Full-Bridge Gate Driver CT, RT programmable oscillator 15.6V Zener Clamp on VCC Micropower Startup Logic Level Latched Shutdown Pin Non-latched shutdown on CT pin (1/6th VCC) Internal bootstrap FETs Excellent Latch Immunity on All Inputs & Outputs ESD Protection on All Pins 14-lead SOIC or PDIP package 1.0 usec (typ.) internal deadtime
Description
The IRS2453D is based on the popular IR2153 self-oscillating half-bridge gate driver IC, and incorporates a high voltage fullbridge gate driver with a front end oscillator similar to the industry standard CMOS 555 timer. HVIC and latch immune CMOS technologies enable ruggedized monolithic construction. The output driver features a high pulse current buffer stage designed for minimum driver cross-conduction. Noise immunity is achieved with low di/dt peak of the gate drivers, and with a undervoltage lockout hysteresis greater than 1.5V. The IRS2453D also includes latched and non-latched shutdown pins.
Package
14 Lead PDIP IRS2453DPbF
14 Lead SOIC (Narrow Body) IRS2453DSPbF
Typical Connection Diagram
+ AC rectified line
15V
1 VCC
VB1 14
IRS2453D
2 COM 3 CT 4 RT 5 SD 6 LO1 7 LO2
HO1 13 VS1 12 NC 11 VB2 10 HO2 9 VS2 8
LOAD
- AC rectified line
*
Please note that this datasheet contains advanced information which could change before the product is released to production.
1
IRS2453DPbF
www.DataSheet4U.com
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters are absolute voltages referenced to COM, all currents are defined positive into any lead. The thermal resistance and power dissipation ratings are measured under board mounted and still air conditions.
Symbol
VB1, VB2 VS1, VS2 VHO1, VHO2 VLO1, VLO2 VRT VCT VSD IRT ICC dVS/dt PD PD RθJA RθJA TJ TS TL
Parameter Definition
High Side Floating Supply Voltage High Side Floating Supply Offset Voltage High-Side Floating Output Voltage Low-Side Output Voltage RT Pin Voltage CT Pin Voltage SD Pin Voltage RT Pin Current Supply Current (Note 1) Allowable Offset Voltage Slew Rate Maximum Power Dissipation @ TA ≤ +25ºC, 8-Pin DIP Maximum Power Dissipation @ TA ≤ +25ºC, 8-Pin SOIC Thermal Resistance, Junction to Ambient, 8-Pin DIP Thermal Resistance, Junction to Ambient, 8-Pin SOIC Junction Temperature Storage Temperature Lead Temperature (Soldering, 10 seconds)
Min.
-0.3 VB - 25 VS - 0.3 -0.3 -0.3 -0.3 -0.3 -5 ---50 ---------55 -55 ---
Max.
625 VB + 0.3 VB + 0.3 VCC + 0.3 VCC + 0.3 VCC + 0.3 VCC + 0.3 5 25 50 1.0 0.625 125 200 150 150 300
Units
V V V V V V V mA mA V/ns W W ºC/W ºC/W ºC
Note 1: This IC contains a zener clamp structure between the chip VCC and COM which has a nominal breakdown voltage of 15.6V. Please note that this supply pin should not be driven by a DC, low impedance power source greater than the VCLAMP specified in the Electrical Characteristics section.
2
IRS2453DPbF
www.DataSheet4U.com
Recommended Operating Conditions
For proper operation the device should be used within the recommended conditions.
Symbol
VBS1, VBS2 VS1, VS2 VCC ICC TJ
Parameter Definition
High Side Floating Supply Voltage Steady State High Side Floating Supply Offset Voltage Supply Voltage Supply Current Junction Temperature
Min.
VCC - 0.7 -3.0 (Note 2) VCCUV+ (Note 3) -25
Max.
VCLAMP 600 VCLAMP 5 125
Units
V V V mA ºC
Note 2: Care should be taken to avoid output switching conditions where the VS node flies inductively below ground by more than 5V. Note 3: Enough current should be supplied to the VCC pin of the IC to keep the internal 15.6V zener diode clamping the voltage at this pin.
Recommended Component Values
Symbol
RT CT
Parameter Component
Timing Resistor Value CT Pin Capacitor Value
Min.
1 330
Max.
-----
Units
kΩ pF
VBIAS (VCC, VBS) = 14V, VS=0V and TA = 25°C, CLO1=CLO2 = CHO1=CHO2 = 1nF.
IRS2453D Frequency vs. RT
1000000 CT Values 100000 Frequency (Hz) 10000 1000 100 10 1000 330pf 470pF 1nF 2.2nF 4.7nF 10nF
10000
100000
1000000
RT (Ohm)
3
IRS2453DPbF
www.DataSheet4U.com
Electrical Characteristics
VBIAS (VCC, VBS) = 14V, CT = 1 nF and TA = 25°C unless otherwise specified. The VO and IO parameters are referenced to COM and are applicable to the respective output leads: HO or LO. CLO1=CLO2=CHO1=CHO2=1nF.
Symbol
VCCUV+ VCCUVVCCUVHYS IQCCUV IQCC VCLAMP
Definition
Rising VCC Undervoltage Lockout Threshold Falling VCC Undervoltage Lockout Threshold VCC Undervoltage Lockout Hysteresis Micropower Startup VCC Supply Current Quiescent VCC Supply Current VCC Zener Clamp Voltage
Min
10.0 8.0 1.6 ----14.6
Typ
11.0 9.0 2.0 140 1.3 15.6
Max
12.0 10.0 2.4 200 2.0 16.6
Units
Test Conditions
Low Voltage Supply Characteristics V µA mA V ICC = 5mA VCC ≤ VCCUV-
Floating Supply Characteristics IQBS1UV, IQBS2UV IQBS1, IQBS2 VBS1UV+, VBS2UV+ VBS1UV-, VBS2UV-, ILK1, ILK2 VBS.