Filter specification
tfs400.doc
version 1.3 06.01.02 _______________________________________________________________________________________...
Description
tfs400.doc
version 1.3 06.01.02 ______________________________________________________________________________________________________
VI TELEFILTER Filter specification TFS 400 1/4 ______________________________________________________________________________________________________
Application
The filter is suitable for GSM, DCS 1800 and dual band receivers. It can especially be used in the first IF in which full channel selectivity is not necessary. Due to the high frequency the filter is small, thus it saves cost and space on the printed circuit board. As it has symmetrical input and output it does not need any transformation networks in state of the art IC transceiver concepts in which symmetrical inputs and outputs are favourable.
Measurement condition
Ambient temperature: 23 °C Input power level: 0 dBm Source impedance: balanced 800 Ω II - 0.7 pF Load impedance: balanced 800 Ω II - 0.7 pF
www.DataSheet4U.com
Construction and pin configuration
see page 2
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 400_1 is the minimum of the pass band attenuation amin. The minimum of the pass band attenuation amin is defined as the insertion loss ae. The centre frequency fo is the arithmetic mean value of the upper and lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed on 400,000 MHz without tolerance. The given values for the relative attenuation arel and for the group...
Similar Datasheet