AVR-PG1B

AVR-PG1B (SERIAL PORT) 10 PIN ICSP AVR MICROCONTROLLER PROGRAMMER Features: AVR-P1B is low cost serial port programmer for AVR microcontrollers with following features: - Connects to RS232 port - Uses target board power supply so no need for external power supply www.DataSheet4U.com Programming: AVR-PG1B works with PonyProg software by from Claudio Lanconelli and the latest release may be download for free from http://www.lancos.com ICSP interface: The ICSP connector is 2x5 pin with 0,1" step and Atmel STKxxx compatible layout. The PIN.1 is marked with square pad on bottom and arrow on top. ICSP signals are: 1- MOSI, 2- VCC, 3- NC, 4- GND, 5- RST, 6- GND, 7- SCK, 8- GND, 9MISO, 10- GND ICSP TOP view PCB board layout: RS232 interface: Your RS232 cable must provide the following signals for properly operation of AVR-PG1B: Tx, Rx, CTS, DTR, RTS, GND. Supported devices: Current supported devices by PonyProg are: AT90S1200, AT90S2313, AT90S2323, AT90S2343, AT90S4414, AT90S4434, AT90S8515, AT90S8535, AT90S2323, AT90S2343, AT90S2333, AT90S4433, AT90S4434, AT90S8535, AT90S8534, ATmega103, ATmega161, ATmega163, ATmega323, ATmega128, ATmega8, ATmega16, ATmega64, ATtiny12 and ATtiny15 Ordering codes: AVR-PG1B - assembled and tested Copyright(c) 2002, OLIMEX Ltd, All rights reserved. Development boards for PIC, AVR and MSP430 microcontrollers http://www.olimex.com/dev ...