Document
HA17358A Series
Dual Operational Amplifier
REJ03D0676-0400 Rev.4.00 Mar 10, 2006
Description
HA17358A series are dual operational amplifier that provide high gain and internal phase compensation, with single power supply. They can be widely applied to control equipments and to general use.
www.DataSheet4U.com
Features
• Wide range of supply voltage, and single power supply used • Wide range of common mode voltage, and possible to operate with an input about 0 V, and output around 0 V is available • Frequency characteristics and input bias current are temperature compensated • Low electro-magnetic susceptibility level
Measurement Condition
Rf Vcc = +7.5 V Vee = −7.5 V Rs Rs Rf 0.01 µ Vin −10 dBm RF signal source (for quasi-RF noise) Vout V _ (= 100∗Vio)
5.0
Output Offset Voltage vs. Input Interference
Output offset voltage (arb. unit)
− +
4.0 3.0 2.0 1.0 0 −1.0 100E+3 HA17358A series HA17358 series
Improvement
1E+6
10E+6 100E+6 1E+9 Input RF frequency (Hz)
10E+9
Ordering Information
Type No. HA17358A HA17358AF HA17358ARP HA17358AT Application Commercial use Package Name DIP-8 pin SOP-8 pin (JEITA) SOP-8 pin (JEDEC) TSSOP-8 pin Package Code PRDP0008AF-B PRSP0008DE-B PRSP0008DD-C PTSP0008JC-B
Rev.4.00 Mar 10, 2006 page 1 of 7
HA17358A Series
Pin Arrangement
Vout1 Vin(−)1 Vin(+)1 1 1 − + 2 + − 8 VCC Vout2 Vin(−)2 Vin(+)2
2
7
3
6
GND
4
5
(Top View)
www.DataSheet4U.com
Circuit Schematic (1/2)
Q5 Vin(−) Q1 Q2 Q3 Q4 Q6 C Q7 R1 Vin(+) Q11 Q10 Q8 Q9 Q12 Q13 Vout
Note: If Input/Output terminals voltage over the absolute maximum ratings, there is possibility of mis-operation, characteristics deterioration and destruction, because of the current’s flowing to parasitic diode in IC. The Input/Output terminals are recommended to be protected with the clamp circuit which using the diode with low forward voltage (like schottky barrier diode) when there is a possibility for the Input/Output terminals voltage exceeds the absolute maximum ratings.
Rev.4.00 Mar 10, 2006 page 2 of 7
HA17358A Series
Absolute Maximum Ratings
(Ta = 25°C)
Item Power supply voltage Output sink current Common mode input voltage Differential input voltage Output voltage Allowable power dissipation Symbol VCC Iosink VCM Vin(diff) Vout PT Ratings 32 50 −0.3 to +VCC ±VCC −0.3 to +VCC 570 *1 385 *2 192 *3 −40 to +85 −55 to +125 Unit V mA V V V mW
DIP SOP TSSOP
Operating temperature
www.DataSheet4U.com Storage temperature
Topr Tstg
°C °C
Notes: 1. HA17358A: This is the allowable values up to Ta = 50°C. Derate by 8.3 mW/°C. 2. HA17358AF/ARP: These are the allowable values up to Ta = 25°C mounting in air. When it is mounted on glass epoxy board of 40 mm × 40 mm × 1.5 mmt with 30% wiring density, the allowable value is 570 mW up to Ta = 45°C. If Ta > 45°C, derate by 7.14 mW/°C. 3. HA17358AT: These are the allowable values up to Ta = 25°C. Derate by 1.92 mW/°C above that temperature.
Electrical Characteristics
(VCC = +15 V, Ta = 25°C)
Item Input offset voltage Input.
Similar Datasheet