3-Channel Charge-Pump LED Driver
PRODUCT DATASHEET
AAT3103
ChargePumpTM
General Description
The AAT3103 is a constant frequency charge-pump based curren...
Description
PRODUCT DATASHEET
AAT3103
ChargePumpTM
General Description
The AAT3103 is a constant frequency charge-pump based current-source white LED driver capable of driving one to three LEDs up to 30mA, each. The charge pumps automatically switch between 1x mode and 2x mode to maintain the highest efficiency and optimal LED current accuracy and matching. A low external parts count (one 1μF flying capacitor, two small 1μF capacitors at IN and OUT and one current setting resistor) makes the AAT3103 ideally suited for small battery-powered applications. www.DataSheet4U.com The AAT3103-1/-2 uses AnalogicTech's Simple Serial Control™ (S2Cwire™) interface to enable, disable, and program the LED driving current. The AAT3103-4 employs a Pulse Width Modulation (PWM) signal with up to 50kHz frequency, 10% to 100% duty cycle to program the LED current. A low-current shutdown feature disconnects the load from IN and reduces quiescent current to less than 1μA. Built-in soft-start circuitry prevents excessive inrush current during start-up. Integrated short circuit and thermal protection circuitry protects the device from damage. The AAT3103 is available in a 2x2.1mm thermally enhanced Pb-free 10-lead SC70JW-10 package.
3-Channel Charge-Pump LED Driver
Features
Source WLED Driver, up to 3 LEDs at up to 30mA, each Automatic Switching Between 1x and 2x Modes 900KHz Switching Frequency Linear LED Output Current Control ▪ Single-wire, S2Cwire Interface AAT3103-1: 16-step AAT3103-2: 8-step ON/...
Similar Datasheet