STLVDS31

www.DataSheet4U.com STLVDS31 HIGH SPEED DIFFERENTIAL LINE DRIVERS s s s s s s s s s MEETS OR EXCEEDS THE REQUIREMENTS OF ANSI TIA/EIA-644 STANDARD LOW VOLTAGE DIFFERENTIAL SIGNALING WITH TYPICAL OUTPUT VOLTAGE OF 350mV AND A 100Ω LOAD TYPICAL OUTPUT VOLTAGE RISE AND FALL TIMES OF 750ps (400Mbps) TYPICAL PROPAGATION DELAY TIMES OF 1.7ns OPERATES FROM A SINGLE 3.3V SUPPLY POWER DISSIPATION 25mW TYPICAL PER DRIVER AT 200MHz DRIVER AT HIGH IMPEDANCE WHEN DISABLED OR WITH VCC =0V PIN COMPATIBLE WITH THE AM26LS31, SN65LVD31 LOW VOLTAGE TTL (LVTTL) LOGIC INPUT LEVELS SOP TSSOP DESCRIPTION The STLVDS31 is a quad differential line drivers that implements the electrical characteristics of low voltage differential signaling (LVDS). This signaling technique lowers the output voltage levels of 5V differential standard levels (such as TIA/EIA-422B) to reduce the power, increase the switching speeds and allows operations with a ORDERING CODES Type STLVDS31BD STLVDS31BDR STLVDS31BTR Temperature Range -40 to 85 °C -40 to 85 °C -40 to 85 °C 3.3V supply rail. Any of the four current mode drivers will deliver a minimum differential output voltage magnitude of 247mV into a 100Ω load when enabled. The intended application of this device and signalling technique is for point-to-point baseband data transmission over controlled impedance media approximately 100Ω. The transmission media may be printed circuit board traces, backplanes or cables. The ultimate rate and distance of data trans...