DatasheetsPDF.com

TFS299 Dataheets PDF



Part Number TFS299
Manufacturers Vectron International
Logo Vectron International
Description Filter specification
Datasheet TFS299 DatasheetTFS299 Datasheet (PDF)

www.DataSheet4U.com Filename: tfs 299.doc Version 1.8 17.09.2004 VI TELEFILTER Measurement condition Ambient temperature: Input power level: Source impedance: Load impedance: Terminating impedance: * Input: Output: 23°C 0±2 50 50 625 520 dBm Filter specification TFS 299 1/5 II -5,3 pF II -5,1 pF Characteristics Remark: The nominal frequency fN is fixed at 299 MHz. The insertion loss a e is defined as loss value determined at fN. Reference level for the relative attenuation arel of the T.

  TFS299   TFS299


Document
www.DataSheet4U.com Filename: tfs 299.doc Version 1.8 17.09.2004 VI TELEFILTER Measurement condition Ambient temperature: Input power level: Source impedance: Load impedance: Terminating impedance: * Input: Output: 23°C 0±2 50 50 625 520 dBm Filter specification TFS 299 1/5 II -5,3 pF II -5,1 pF Characteristics Remark: The nominal frequency fN is fixed at 299 MHz. The insertion loss a e is defined as loss value determined at fN. Reference level for the relative attenuation arel of the TFS299 is the insertion loss a e. All specified data are met within the operating temperature range. Data Insertion loss (reference level) Nominal frequency Passband Pass band ripple Bandwidth 3 dB Relative attenuation fN fN fN fN ± ± + 1,8 6,0 298,0 60,0 MHz MHz MHz MHz ... ... ... ... fN fN fN fN ± ± + 6,0 60,0 60,0 701,0 ae fN PB p-p BW typ. value arel MHz MHz MHz MHz fN tolerance / limit max. 8,0 299,0 ± 80 ± 0,5 400 dB MHz kHz dB kHz max. min. - min. min. min. min. max. max. max. 20 35 20 20 1 1 +10 dB dB dB dB µs µs dBm Absolute group delay at fN Group delay ripple within PB Input power level Operating temperature range Storage temperature range Temperature coefficient of frequency Frequency inversion temperature TCf ** OTR p-p -0,036 25 ppm/K2 °C -40 °C ... + 85 °C -40 °C ... + 90 °C - *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) fc(Hz) = TCf(ppm/K2) x (T-T0)2 x fTo (MHz). Generated: Checked / Approved: Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 299.doc Version 1.8 17.09.2004 VI TELEFILTER Filter characteristic t.b.d. Filter specification TFS 299 2/5 Construction and pin connection TFS 299 M12 Datecode 1 2 3 4 5 6 7 8 9 10 Datecode: K L M ... Output Ground Ground Ground Ground Input Ground Ground Ground Ground Year+week 1998 1999 2000 1 10 9 8 2 3 4 5 7 6 50 single ended test circuit L1 6 1 L2 Output 50 Ohm C2 Input 50 Ohm C1 SAW 2,3,4,5,7 8,9,10 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 299.doc Version 1.8 17.09.2004 VI TELEFILTER Stability Characteristics Filter specification TFS 299 3/5 After the following tests the filter shall meet the whole specification: 1. Shock: 2. Vibration: 3. Damp heat: (cycle) 4. Resistance to solder heat (reflow): 5. ESD 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 25 °C to 55°C / 95% r.H. / 10 cycles DIN IEC 68 - 2 – 30 Db max. 2 times reflow process; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; MIL-STD-883E using coupling network of ISO 10605 and EN 6100-4-2 HBM:250V;MM:200V; Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: reel of empty components at start: reel of empty components at start including leader: trailer: 3000 min. 300 mm min. 500 mm min. 300 mm Pull Off Direction Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,10 F : 7,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 +0,1/-0 Ao : 7,60 ± 0,10 Bo : 9,60 ± 0,10 Ct : 13,5 Date Code P1 Po P2 t Do Ko Typ PIN Marker D1 Ao W 2 Reel (all dimensions in mm) A : 330 W1 : 16,4 W2(max) : 22,4 N(min) : 50 C : 13,0 C A N W 1 The minimum bending radius is 45 mm. Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: [email protected] VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. Filename: tfs 299.doc Version 1.8 17.09.2004 VI TELEFILTER Air reflow temperature conditions Filter specification TFS 299 4/5 1st and 2nd air re.


TFS2915 TFS299 TLA2276


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site.
(Privacy Policy & Contact)