Power Module for 0.75 hp Motor Drives
PD 6.114 IRPT1058A
PRELIMINARY
IRPT1058A
™
Power Module for 0.75 hp Motor Drives
· 0.75 hp (0.56 kW) power output
Ind...
Description
PD 6.114 IRPT1058A
PRELIMINARY
IRPT1058A
™
Power Module for 0.75 hp Motor Drives
· 0.75 hp (0.56 kW) power output
Industrial rating at 150% overload for 1 minute
· · · · · · · · ·
180-240V AC single-phase input, 50/60 Hz Single-phase rectifier bridge 3-phase, short circuit rated, ultrafast IGBT inverter HEXFRED ultrafast soft recovery freewheeling diodes Low inductance (current sense) shunts in positive and negative DC rail NTC temperature sensor Pin-to-baseplate isolation 2500V rms Easy-to-mount two-screw package Case temperature range -25°C to 125°C operational
Figure 1. IRPT1058A Power Module
IRPT1058C IRPT1058A Power Module IRPT1058D Driver-Plus Board PWM variable frequency output
180-240V single-phase input
AC motor
feedback (non-isolated)
PWM generator
feedback processing
keyboard
Figure 2. The IRPT1058C control system
within a motor
page 1
IRPT1058A
System Description
The IRPT1058A Power Module
The IRPT1058A Power Module, shown in figure 1, is a chip and wire epoxy encapsulated module. It houses input rectifiers, output inverter, current sense shunts and NTC thermistor. The single-phase input bridge rectifiers are rated at 800V. The inverter section employs 600V, short circuit rated, ultrafast IGBTs and ultrafast freewheeling diodes. Current sensing is achieved through 75 mΩ low inductance shunts provided in the positive and negative DC bus rail. The NTC thermistor provides temperature sensing capability. The lead spacing on the power module meets UL840 ...
Similar Datasheet