Power Module for 5 hp Motor Drives
IRPT3054A
PROVISIONAL
IRPT3054A
™
Power Module for 5 hp Motor Drives
· 5 hp (3.7 kW) power output
Industrial rating at...
Description
IRPT3054A
PROVISIONAL
IRPT3054A
™
Power Module for 5 hp Motor Drives
· 5 hp (3.7 kW) power output
Industrial rating at 150% overload for 1 minute
· · · · · · · · · ·
380-480V AC input, 50/60 Hz 3-phase rectifier bridge 3-phase, short circuit rated, ultrafast IGBT inverter HEXFRED ultrafast soft recovery-freewheeling diodes Brake IGBT and diode Low inductance (current sense) shunts in positive and negative DC rail NTC temperature sensor Pin-to-baseplate isolation 2500V rms Easy-to-mount two-screw package Case temperature range -25°C to 125°C operational
Figure 1. IRPT3054A Power Module
380-480V 3-phase input
IRPT3054A Power Module
PWM variable frequency output
Gate Driver Board feedback (non-isolated)
PWM generator
Figure 2. The IRPT3054 power module within a motor control system
page 1
IRPT3054A
Power Module
The IRPT3054A Power Module shown in figure 1 is a chip and wire epoxy encapsulated module. It houses input rectifiers, output inverter, current sense shunts and NTC thermistor. The 3-phase input bridge rectifiers are rated at 1600V. The brake circuit uses 1200V IGBT and freewheeling diode. The inverter section employs 1200V, short circuit rated, ultrafast IGBTs and ultrafast freewheeling diodes. Current sensing is achieved through 25 m low inductance shunts provided in the positive and negative DC bus rail. The NTC thermistor provides temperature sensing capability. The lead spacing on the power module meets UL840 pollution level 3 requirements. The power cir...
Similar Datasheet